Serviceline Industrial Sensors
Serviceline Explosion Protection
Ultrasonic sensor UC2000-30GM-IUEP-IO-V15-Y
- IO-Link interface for service and process data
- Programmable via DTM with PACTWARE
- Switch output and analog output
- Selectable sound lobe width
- Synchronization options
- Temperature compensation
Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
Download the complete datasheet as a PDF:
Datasheet excerpt: Technical data of UC2000-30GM-IUEP-IO-V15-Y
| Product Description |
|---|
| Single head system |
| General specifications | ||
|---|---|---|
| Sensing range | 90 ... 2000 mm | |
| Adjustment range | 120 ... 2000 mm | |
| Dead band | 0 ... 90 mm | |
| Standard target plate | 100 mm x 100 mm | |
| Transducer frequency | approx. 200 kHz | |
| Response delay | minimum : 65 ms factory setting: 125 ms |
|
| Memory | ||
| Non-volatile memory | EEPROM | |
| Write cycles | 100000 | |
| Indicators/operating means | ||
| LED green | solid: Power on flashing: Standby mode or IO link communication |
|
| LED yellow 1 | solid: Object in evaluation range flashing: Learning function, object detected |
|
| LED yellow 2 | solid: Object in evaluation range flashing: Learning function, object detected |
|
| LED red | solid red: Error red, flashing: program function, object not detected |
|
| Electrical specifications | ||
| Operating voltage | 10 ... 30 V DC , ripple 10 %SS 15 ... 30 V voltage output |
|
| No-load supply current | ≤ 60 mA | |
| Power consumption | ≤ 1 W | |
| Time delay before availability | ≤ 120 ms | |
| Interface | ||
| Interface type | IO-Link | |
| Protocol | IO-Link V1.0 | |
| Transfer rate | Acyclical: typical 95 Bit/s | |
| Cycle time | min. 33.6 ms | |
| Mode | COM2 (38.4 kBit/s) | |
| Process data width | 16 bit | |
| SIO mode support | yes | |
| Input/Output | ||
| Input/output type | 1 synchronization connection, bidirectional | |
| 0 Level | 0 ... 1 V | |
| 1 Level | 4 V ... UB | |
| Input impedance | > 12 kΩ | |
| Output current | < 12 mA | |
| Pulse length | 0.5 ... 300 ms (level 1) | |
| Pulse interval | ≥ 33 ms (level 0) | |
| Synchronization frequency | ||
| Common mode operation | ≤ 30 Hz | |
| Multiplex operation | ≤ 33 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 ) |
|
| Output | ||
| Output type | 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected Current output 4 mA ... 20 mA or voltage output 0 V ... 10 V configurable |
|
| Rated operating current | 200 mA , short-circuit/overload protected | |
| Voltage drop | ≤ 2.5 V | |
| Resolution | current output: evaluation range [mm]/3200 but ≥ 0.35 mm voltage output: evaluation range [mm]/4000 but ≥ 0.35 mm |
|
| Deviation of the characteristic curve | ≤ 0.2 % of full-scale value | |
| Repeat accuracy | ≤ 0.1 % of full-scale value | |
| Switching frequency | ≤ 4 Hz | |
| Range hysteresis | 1 % of the adjusted operating range (default settings), programmable | |
| Load impedance | current output: ≤ 300 Ohm voltage output: ≥ 1000 Ohm |
|
| Temperature influence | ≤ 1.5 % from full-scale value (with temperature compensation) ≤ 0.2 %/K (without temperature compensation) |
|
| Compliance with standards and directives | ||
| Standard conformity | ||
| Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003 |
|
| Approvals and certificates | ||
| UL approval | cULus Listed, Class 2 Power Source | |
| CCC approval | CCC approval / marking not required for products rated ≤36 V | |
| Ambient conditions | ||
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Mechanical specifications | ||
| Connection type | Connector plug M12 x 1 , 5-pin | |
| Degree of protection | IP67 | |
| Material | ||
| Housing | Stainless steel 1.4305 / AISI 303 TPU Polyamides |
|
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam | |
| Mass | 72 g | |
| Dimensions | ||
| Length | 93 mm | |
| Diameter | 30 mm | |
| Factory settings | ||
| Output 1 | near switch point: 120 mm far switch point: 2000 mm Output mode: Window mode output behavior: NO contact |
|
| Output 2 | near limit: 120 mm far limit: 1000 mm Output mode: rising ramp output behavior: Current output 4 mA ... 20 mA |
|
| Beam width | wide | |
| General information | ||
| Note | nuts, M30 plastic | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27272803 |
| ECLASS 12.0 | 27272803 |
| ECLASS 11.0 | 27272803 |
| ECLASS 10.0.1 | 27272803 |
| ECLASS 9.0 | 27272803 |
| ECLASS 8.0 | 27272803 |
| ECLASS 5.1 | 27272803 |
| ETIM 9.0 | EC001849 |
| ETIM 8.0 | EC001849 |
| ETIM 7.0 | EC001849 |
| ETIM 6.0 | EC001849 |
| ETIM 5.0 | EC001849 |
| UNSPSC 12.1 | 41111960 |
Details: UC2000-30GM-IUEP-IO-V15-Y
Informative Literature: UC2000-30GM-IUEP-IO-V15-Y
| Literature | Language | File Type | File Size |
|---|---|---|---|
| Application Report - Rugged Collision Protection for Cleaning Robots | ENG | 313 KB |
Product Documentation: UC2000-30GM-IUEP-IO-V15-Y
| Safety and Security Documentation | Language | File Type | File Size |
|---|---|---|---|
| Instruction manual | ENG | 150 KB |
Approvals: UC2000-30GM-IUEP-IO-V15-Y
| Certificates | Certificate No. | Language | File Type | File Size |
|---|---|---|---|---|
| Canada USA UL Ordinary Location | UL-US-2140156-4 / UL-CA-2133660-4 | ALL | 284 KB | |
| IO-Link Manufacturer Declaration | CERT-3037A | ALL | 140 KB | |
| Declaration of Conformity | ||||
| EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F) | DOC-5231A | ALL | 71 KB | |
| UK Declaration of Conformity (P+F) / UK-Konformitäterklärung (P+F) | DOC-5570 | ALL | 64 KB | |
Associated Products: UC2000-30GM-IUEP-IO-V15-Y
| Accessories | ||||||
|---|---|---|---|---|---|---|
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
The USi-safety ultrasonic sensor system is breaking new ground for safety applications—whether in challenging, dusty environments or in outdoor areas.
Pepperl+Fuchs offers you various downloadable documents containing knowledge on ultrasonic sensors.
Pepperl+Fuchs SE
Lilienthalstraße 200
68307 Mannheim
Germany
info@de.pepperl-fuchs.com
+49 621 776-0
© 2024 All Rights Reserved.
Pepperl+Fuchs is a leading developer and manufacturer of electronic sensors and components for the global automation market. Continuous innovation, enduring quality, and steady growth have been the foundation of our success for more than 70 years. Pepperl+Fuchs employs 6,300 people worldwide and has manufacturing facilities in Germany, USA, Singapore, Hungary, Indonesia and Vietnam, most of them ISO 9001 certified.