Stand-alone connecting module VAZ-2E2A-G20-ZPA1

Inputs for 3-wire sensors
Outputs for DC roller motors (drum motors)
Interface for coupling with adjacent zones
Connection of motors and sensors via M8 connectors
Operating mode, motor speed and start/stop ramp can be configured using the rotary switch
Supply of 24 V_DC, connection via insulation piercing technology with gold-plated contact pins
Function indicator for power supply, inputs and outputs, and zone coupling

Technical Data
Informative Literature
Product Documentation
Design / Simulation
Approvals
Software
配套产品

请注意：所有以Pepperl + Fuchs GmbH或Pepperl + Fuchs AG名义发行的产品相关文件，例如证书，合格声明等，同样适用于Pepperl + Fuchs SE。

將完整的規格書下載為PDF:

產品規格摘要：的技術資料 VAZ-2E2A-G20-ZPA1

產品描述
G20 motor control module with an integrated logic function for Interroll EC310, Interoll EC5000 24V AI, Rulmeca BL3, Itoh Denki PM500XK, Itoh Denki PM500XC

General specifications
UL File Number		E223772 "For use in NFPA 79 Applications only"
Compatible roller motors		Interroll EC310, Interroll EC5000 24V AI (20W / 35W / 50W), Rulmeca BL3, Itoh Denki PM500XK, Itoh Denki PM500XC
Indicators/operating means
Switch		S1: motor speed; rotary switch, 10 positions S2: direction of rotation and start/stop ramp; rotary switch, 10 positions S3: operating mode, rotary switch, 10 positions
LED ERR		Motor fault; 2 yellow LEDs yellow: motor error flashing yellow: motor protection unit defective
LED PWR		Supply voltage U_PWR; green LED
LED IN		switching state (input); 2 LED yellow
LED MOT		Motor active; 2 yellow LEDs
LED XIN		Zone coupling input active; 2 yellow LEDs
LED XOUT		Zone coupling output active; 2 yellow LEDs
Electrical specifications
Rated operating voltage		18 V ... 30 V DC PELV (via U_PWR)
Rated operating current		≤ 30 mA (Closed-circuit current) max. 10 A (<2 s)
Surge protection		U_PWR: overvoltage category II, securely isolated power supply (PELV)
Interface 1
Interface type		Interface for coupling zones with one input and one output for control signals X1
Physical		4-pin M12 socket Electronic output: PNP, overload and short-circuit proof (X1OUT) Input: PNP, galvanically isolated, potential-free (X1IN)
Load current		Input: ≤ 8 mA (internally limited) Output: 10 mA
Voltage		Input: max. 30 V DC Output (via U_PWR): ≥ (U_PWR - 2 V)
Switching point		in accordance with DIN EN 61131-2 (type 1) 0 (undamped): ≤ 0.5 mA 1 (damped): ≥ 2 mA
Interface 2
Interface type		Interface for coupling zones with one input and one output for control signals X2
Physical		M12 connector, 4-pin Electronic output: PNP, overload and short-circuit proof (X2OUT) Input: PNP, galvanically isolated, potential-free (X2IN)
Load current		Input: ≤ 8 mA (internally limited) Output: 10 mA
Voltage		Input: max. 30 V DC Output (via U_PWR): ≥ (U_PWR - 2 V)
Switching point		in accordance with DIN EN 61131-2 (type 1) 0 (undamped): ≤ 0.5 mA 1 (damped): ≥ 2 mA
Input
Number/Type		2 Inputs for 3-wire sensors (PNP), DC
Supply		via U_PWR
Current loading capacity		500 mA , overload and short-circuit protected
Input current		≤ 8 mA (limited internally)
Switching point		according to DIN EN 61131-2 0 (undamped) ≤ 0.5 mA 1 (damped) ≥ 2.0 mA
Input filter		10 ms
Output
Number/Type		2 outputs for DC roller motors (MOT1, MOT2)
Supply		via U_PWR
Current		3.5 A continuous current , 5 A (<2 s) , max. 7.5 A (<0,3 s) per motor
Overload protection		Fuse 5 A, I²t = 53.7 A²s per motor
Velocity signal		1.4 … 13 V at no-load R_i = 5.6 kΩ, R_LOAD ≥ 35 kΩ Control using rotary switch S1
Rotation direction signal		low: high impedance high; ≥ (U_PWR - 1.0 V) in no-load operation R_i = 5.6 kΩ, R_LOAD ≥ 5 kΩ Control using rotary switch S2
Motor fault		NPN digital input, U₀ = 14 V, R_i = 34 kΩ 0 (no error) ≥ 125 µA 1 (error) ≤ 25 µA
Directive conformity
Electromagnetic compatibility
	Directive 2014/30/EU	EN 61326-1:2006
Standard conformity
Degree of protection		EN 60529:2000
Input		EN 61131-2:2007
Emitted interference		EN 61000-6-4:2007
Noise immunity		EN 61000-6-2:2005 , EN 61326-1:2006
Ambient conditions
Ambient temperature		-30 ... 60 °C (-22 ... 140 °F)
Storage temperature		-30 ... 85 °C (-22 ... 185 °F)
Relative humidity		85 % non-condensing
Climatic conditions		For indoor use only
Altitude		≤ 2000 m above MSL
Shock and impact resistance		30 g, 11 ms in 6 spatial directions, 3 shocks 10 g, 16 ms in 6 spatial directions, 1000 shocks
Vibration resistance		0.75 mm 10 ... 57 Hz , 5 g 57 ... 150 Hz, 20 cycles
Pollution degree		2
Mechanical specifications
Degree of protection		IP65 in accordance with EN 60529 (not certified by UL)
Connection		PWR: insulation piercing technology Black flat cable Inputs/outputs: M8 round plug connector in accordance with EN 61076-2-104 Inputs: LF004-GS1-A (4-pin, bushing contacts, screw lock, A-coded) Matching connector: LM004-Gx1-A or similar Outputs: NF005-SS1-B (5-pin, bushing contacts, snap lock, B-coded) Matching connector: NM005-Sx1-B or similar Zone coupling: M12 round plug connector in accordance with EN 61076-2-101 X1: M12, 4-pin, bushing contacts, screw-locking, A-coded Female connector: M12, 4-pin, connector contacts, screw-locking, A-coded X2: M12, 4-pin, connector contacts, screw-locking, A-coded Female connector: M12, 4-pin, bushing contacts, screw-locking, A-coded
Mass		310 g
Dimensions
	Height	27.5 mm
	Width	131.5 mm
	Length	54 mm
Mounting		2 clips with ∅ 8 mm drill hole
Cable length		1 m (inputs/outputs) , 1.5 m (zone coupling), max. 30 m
Note		The flat cable routing is designed for 100 actuation cycles

Classifications

System	Classcode
ECLASS 13.0	27242604
ECLASS 12.0	27242604
ECLASS 11.0	27242604
ECLASS 10.0.1	27242604
ECLASS 9.0	27242604
ECLASS 8.0	27242604
ECLASS 5.1	27242604
ETIM 9.0	EC001599
ETIM 8.0	EC001599
ETIM 7.0	EC001599
ETIM 6.0	EC001599
ETIM 5.0	EC001599
UNSPSC 12.1	39121535

Details: VAZ-2E2A-G20-ZPA1

Informative Literature: VAZ-2E2A-G20-ZPA1

Literature	語言	檔案類型	檔案尺寸
Product Information - G20 ZPA Motor Control Module	ENG	PDF	645 KB

Product Documentation: VAZ-2E2A-G20-ZPA1

Brief Instructions	語言	檔案類型	檔案尺寸
Instruction leaflet / Beipackzettel	ALL	PDF	157 KB
Configuration Instructions	ENG	PDF	51 KB
Manuals
Manual	ENG	PDF	1697 KB

Design / Simulation: VAZ-2E2A-G20-ZPA1

CAD	語言	檔案類型	檔案尺寸
CAD 3-D / CAD 3-D	ALL	STP	1738 KB
CAE
CAE EPLAN Data Portal / CAE EPLAN Data Portal	ALL	LINK	---
CAE EPLAN macro EDZ / CAE EPLAN Makro EDZ	ALL	EDZ	477 KB

Approvals: VAZ-2E2A-G20-ZPA1

Certificates	證書號碼	語言	檔案類型	檔案尺寸
Canada, USA UL	2019-2-25, 2019-07-29 (A1/C0), 2020-10-21 (A2/C0); 2024-08-28 (A3/C0)-E223772	ALL	PDF	523 KB
Declaration of Conformity
EU-Declaration of conformity	TDOC-5108AENG	ENG	PDF	197 KB

Software: VAZ-2E2A-G20-ZPA1

Software Tools	發布資訊	檔案類型	檔案尺寸
Interactive animation software of function logic for different operating modes / Interaktive Animationssoftware zur Funktionslogik der verschiedenen Betriebsarten	2019-01	ZIP	138977 KB

相關產品: VAZ-2E2A-G20-ZPA1

Accessories

	V1-G-BK0,75M-PUR-U-V1-G-Y285728 Adapter cable
	Adapter cable M12 socket straight to M12 socket straight A-coded, 4-pin crossed, PUR cable black, UL approved, drag chain suitable, torsion resistantfa

	V1S-G-BK0,75M-PUR-U-V1S-G-Y285720 Adapter cable
	Adapter cable M12 plug straight to M12 plug straight A-coded, 4-pin crossed, PUR cable black, UL approved, drag chain suitable, torsion resistantfa

	VAZ-ZPA-ANALYZER Diagnostic adapter
	Diagnostic adapter for G20 ZPA motor control modulefa

	V311-GR-BK1M-PUR-U-V311-GR Connection cable
	Cordset M8 socket snap-lock straight to M8 plug snap-lock straight B-coded, 5-pin, PUR cable black, UL-approved, drag chain suitable, torsion resistantfa

	V311-GR-BK2M-PUR-U-V311-GR Connection cable
	Cordset M8 socket snap-lock straight to M8 plug snap-lock straight B-coded, 5-pin, PUR cable black, UL-approved, drag chain suitable, torsion resistantfa

	VAZ-G10-LIMITER Voltage limiter
	Voltage limiter G10fa

General Notes Relating to Pepperl+Fuchs Product Information

Free Download: White Paper on TCP-Based Communication Protocols (PDF)

免费下载：基于 TCP 标准的通信协议白皮书 (PDF)

这份免费的 PDF 白皮书比较了不同的基于TCP标准的通信协议（包括 AMQP、OPC UA、MQTT、REST API），这些协议已成为 IIoT 和工业 4.0 的推动力。立即免费下载！

AS-Interface Switch Cabinet Module KE5 – Simple Handling and Improved Manageability

The unique housing design of the new KE5 switch cabinet module enables distinct visibility and simplifies mounting, wiring, and maintenance inside switch cabinets and junction boxes.

Download the AS-Interface Product Overview

Get to know our full range of AS-Interface products.

台灣倍加福有限公司
信義路5段150巷2號21樓之4
信義區
11059 台北市臺灣
臺灣
fa-info@tw.pepperl-fuchs.com
phone +886 2 27227708

Pepperl+Fuchs 倍加福是領先全球的電子感測器 和 零組件的開發與製造商. 超過七十年的不斷創新、穩定的品質與持續的業績增長，成就了今日的我們， Pepperl+Fuchs 倍加福在全球擁有 6,300 名員工，並在德國、美國、新加坡、匈牙利、印尼和越南都設有製造工廠，其中多數工廠已通過 ISO 9001 認證