请注意：所有以Pepperl + Fuchs GmbH或Pepperl + Fuchs AG名义发行的产品相关文件，例如证书，合格声明等，同样适用于Pepperl + Fuchs SE。
產品規格摘要：的技術資料
NRN40-L3K-E2-IO-V1
| General specifications |
| Switching function | Normally open/closed (NO/NC) programmable |
| Output type | PNP |
| Rated operating distance | 40 mm (factory setting) |
| Near operating distance | 35 mm (can be activated by software) |
| Installation | non-flush |
| Output polarity | DC |
| Assured operating distance | 0 ... 32.4 mm |
| Reduction factor rAl | 1 |
| Reduction factor rCu | 1 |
| Reduction factor r304 | 1 |
| Reduction factor rSt37 | 1 |
| Output type | 3-wire |
| Nominal ratings |
| Operating voltage | 10 ... 30 V DC |
| Switching frequency | 0 ... 180 Hz (switch point mode)
0 ... 30 Hz (window mode, switch point mode with stability alarm) |
| Hysteresis | typ. 3 % |
| Reverse polarity protection | reverse polarity protected |
| Short-circuit protection | pulsing |
| Voltage drop | ≤ 0.5 V |
| Operating current | 0 ... 200 mA |
| Off-state current | 0 ... 0.5 mA typ. 60 µA at 25 °C |
| No-load supply current | ≤ 20 mA |
| Time delay before availability | max. 150 ms |
| Constant magnetic field | 200 mT |
| Alternating magnetic field | 200 mT |
| Operating voltage indicator | LED, green |
| Status indicator | LED, yellow |
| Functional safety related parameters |
| MTTFd | 701 a |
| Mission Time (TM) | 20 a |
| Diagnostic Coverage (DC) | 0 % |
| Interface |
| Interface type | IO-Link ( via C/Q = pin 4 ) |
| IO-Link revision | 1.1 |
| Device ID | 0x201002 (2101250) |
| Transfer rate | COM2 (38.4 kBit/s) |
| Min. cycle time | 2.3 ms |
| Process data width | Process data input (control system side): 2 Bit
Process data output (control system side): none |
| SIO mode support | yes |
| Compatible master port type | A |
| Compliance with standards and directives |
| Standard conformity | |
| Standards | EN IEC 60947-5-2 |
| Approvals and certificates |
| Protection class | II |
| Rated insulation voltage | 60 V |
| Rated impulse withstand voltage | 800 V |
| UL approval | cULus Listed, General Purpose
Class 2 power source |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| Ambient conditions |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
| Mechanical specifications |
| Connection type | Connector plug M12 x 1 , 4-pin |
| Housing material | GD-ZnAl4Cu1, coated
mounting flange PA6-GF35 |
| Sensing face | PA 6 Grivory GVN-35H |
| Degree of protection | IP67 |
| Mass | 190 g |
| Dimensions | |
| Height | 40 mm |
| Width | 40 mm |
| Length | 67 mm |
| Factory settings |
| Default setting | operating mode = switch point mode with stability alarm
switching function = Normally open (NO)
switching distance = 40 mm |
Classifications
| System | Classcode |
| ECLASS 13.0 | 27274001 |
| ECLASS 12.0 | 27274001 |
| ECLASS 11.0 | 27270101 |
| ECLASS 10.0.1 | 27270101 |
| ECLASS 9.0 | 27270101 |
| ECLASS 8.0 | 27270101 |
| ECLASS 5.1 | 27270101 |
| ETIM 9.0 | EC002714 |
| ETIM 8.0 | EC002714 |
| ETIM 7.0 | EC002714 |
| ETIM 6.0 | EC002714 |
| ETIM 5.0 | EC002714 |
| UNSPSC 12.1 | 39121550 |
Details:
NRN40-L3K-E2-IO-V1
Product Documentation:
NRN40-L3K-E2-IO-V1
Design / Simulation:
NRN40-L3K-E2-IO-V1
Approvals:
NRN40-L3K-E2-IO-V1
Software:
NRN40-L3K-E2-IO-V1
相關產品:
NRN40-L3K-E2-IO-V1
| Accessories |
|
|
|
| Female cordset single-ended M12 straight A-coded, 4-pin, PVC cable greyfa |
|
|
|
|
| Female cordset, M12, 4-pin, PVC cablefa |
|
|
|
|
| Modular mounting bracket fa |
|
|
|
|
| Mounting aid for VariKont-Lfa |
|
|
|
|
| Mounting aid for VariKont, +U1+ and +U9* fa |
|
|
|
|
| EtherNet/IP IO-Link master with 8 inputs/outputsfa |
|
|
|
|
|
| PROFINET IO IO-Link master with 8 inputs/outputsfa |
|
|
|
|
| EtherNet/IP IO-Link master with 8 inputs/outputs, DIN rail, screw terminalfa |
|
|
|
|
| PROFINET IO IO-Link master with 8 inputs/outputs, DIN rail, push-in terminalsfa |
|
|
|
|
|
| PROFINET IO IO-Link master with 8 inputs/outputs, DIN rail, screw terminalfa |
|
|
|
|
| IO-Link master, supply via USB port or separate power supply, LED indicators, M12 plug for sensor connectionfa |
|
|
|
|
| Ethernet IO-Link module with 8 inputs/outputsfa |
|
|
|
|
| Ethernet IO-Link module with 8 inputs/outputsfa |
|
|
|
|
|
| EtherNet/IP IO-Link master with 8 inputs/outputs, DIN rail, push-in connectorsfa |
|
+886 2 27227708