Ultrasonic sensor UC500-L2M-U-T-2M

Extended temperature range
Cable connection
Rugged metal base
Sensor head bidirectional and rotatable
Function indicators visible from all directions
Selectable sound lobe width
Programmable

Technical Data
Informative Literature
Product Documentation
Design / Simulation
Approvals
Software
配套产品

请注意：所有以Pepperl + Fuchs GmbH或Pepperl + Fuchs AG名义发行的产品相关文件，例如证书，合格声明等，同样适用于Pepperl + Fuchs SE。

將完整的規格書下載為PDF:

產品規格摘要：的技術資料 UC500-L2M-U-T-2M

產品描述
Single head system

General specifications
Sensing range		35 ... 500 mm
Adjustment range		50 ... 500 mm
Dead band		0 ... 35 mm
Standard target plate		100 mm x 100 mm
Transducer frequency		approx. 380 kHz
Nominal ratings
Response delay		minimum: 20 ms factory setting: 145 ms
Time delay before availability		≤ 1600 ms
Indicators/operating means
LED green		Operating display
LED yellow		object in evaluation range
LED red		error
Electrical specifications
Operating voltage		12 ... 30 V DC , ripple 10 %_SS
No-load supply current		≤ 50 mA
Interface
Interface type		Serial interface (programming adapter required) 9600 BPS, no parity, 8 data bits, 1 stop bit
Input/Output
Input/output type		1 synchronization connection, bidirectional
	0 Level	0 ... 1 V
	1 Level	4 V ... U_B
	Input impedance	> 12 kΩ
	Output current	< 12 mA
	Pulse length	0.5 ... 300 ms (level 1)
	Pulse interval	≥ 14 ms (level 0)
Synchronization frequency
	Common mode operation	≤ 70 Hz
	Multiplex operation	≤ 90 Hz / n , n = number of sensors , n ≤ 10 (factory setting: n = 5 )
Input
Input type		1 program input
Level (evaluation limit 1)		0 ... 1 V
Level (evaluation limit 2)		4 V ... U_B
Input impedance		> 12 kΩ
Pulse length		2 ... 10 s
Output
Output type		1 analog output 0 ... 10 V
Resolution		evaluation range [mm]/4000, but ≥ 0.05 mm
Deviation of the characteristic curve		≤ 0.2 % of full-scale value
Repeat accuracy		≤ 0.1 % of full-scale value
Load impedance		≥ 500 Ohm
Temperature influence		≤ 1.5 % of full-scale value
Compliance with standards and directives
Standard conformity
	Standards	EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 EN 60947-5-7:2003 IEC 60947-5-7:2003
Approvals and certificates
UL approval		cULus Listed, General Purpose
CCC approval		CCC approval / marking not required for products rated ≤36 V
Ambient conditions
Ambient temperature		-40 ... 70 °C (-40 ... 158 °F)
Storage temperature		-40 ... 85 °C (-40 ... 185 °F)
Mechanical specifications
Connection type		cable , 5-pin
Degree of protection		IP67
Material
	Housing	PA-GF35
	Cable	PUR
	Transducer	epoxy resin/hollow glass sphere mixture; polyurethane foam
Cable
	Sheath diameter	7.25 mm
	Bending radius	> 37.3 mm , fixed installation > 74.7 mm , movable installation
	Core cross section	5 x 0.82 mm²
	Length	2 m
Mass		345 g
Dimensions
	Height	40 mm
	Width	40 mm
	Length	40 mm
Factory settings
Output		near limit: 50 mm far limit: 500 mm Output mode: rising ramp
Beam width		wide
Evaluation procedure		low-pass behavior
General information
Supplementary information		Switch settings of the external programming adapter: "output load": pull-down "output logic": noninv

Classifications

System	Classcode
ECLASS 13.0	27272803
ECLASS 12.0	27272803
ECLASS 11.0	27272803
ECLASS 10.0.1	27272803
ECLASS 9.0	27272803
ECLASS 8.0	27272803
ECLASS 5.1	27272803
ETIM 9.0	EC001849
ETIM 8.0	EC001849
ETIM 7.0	EC001849
ETIM 6.0	EC001849
ETIM 5.0	EC001849
UNSPSC 12.1	41111960

Details: UC500-L2M-U-T-2M

Informative Literature: UC500-L2M-U-T-2M

Literature	語言	檔案類型	檔案尺寸
Application Report - Rugged Collision Protection for Cleaning Robots	ENG	PDF	313 KB
Application Report - Ultrasonic Technology - Reliable Web Tension Monitoring	ENG	PDF	811 KB

Product Documentation: UC500-L2M-U-T-2M

Brief Instructions	語言	檔案類型	檔案尺寸
Commissioning instruction UC-L2IU* / Inbetriebnahmeanleitung UC-L2IU*	ALL	PDF	457 KB
Safety and Security Documentation
Instruction manual	ENG	PDF	150 KB

Design / Simulation: UC500-L2M-U-T-2M

CAD	語言	檔案類型	檔案尺寸
CAD 3-D / CAD 3-D	ALL	STP	1553 KB
CAD Portal / CAD Portal	ALL	LINK	---

Approvals: UC500-L2M-U-T-2M

Certificates	證書號碼	語言	檔案類型	檔案尺寸
Canada USA UL Ordinary Location	UL-US-2153066-0 / UL-CA-2144586-0	ALL	PDF	546 KB
Declaration of Conformity
EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F)	DOC-4225A	ALL	PDF	47 KB
UK Declaration of Conformity (P+F) / UK-Konformitäterklärung (P+F)	DOC-5521	ALL	PDF	40 KB

Software: UC500-L2M-U-T-2M

Device Description Files/Drivers	發布資訊	檔案類型	檔案尺寸
DTM for L2 and UMC3000 devices / DTM für Geräte der Serien L2 und UMC3000	1.3.0.0 / 30-07-2022	ZIP	5005 KB
Software Tools
PACTware 4.1 SP6 / PACTware 4.1 SP6	4.1.0.53	ZIP	43327 KB
PACTware 5.0 / PACTware 5.0	5.0.5.31	ZIP	44203 KB

相關產品: UC500-L2M-U-T-2M

Accessories

	UC-PROG1-USB Programming adapter
	Programming adapter, USB 2.0 interface, Simple insertion in the sensor connection leadfa

	V15S-G-0,3M-PUR-WAGO Cable connector
	Male cordset, M12, 5-pin, PUR cable with WAGO terminalsfa

General Notes Relating to Pepperl+Fuchs Product Information

符合 Category 3 PL d 標準，實現可靠防護

USi-safety 超音波感測器系統為安全應用開闢了新的領域，無論是在充滿挑戰性的、多塵的環境中還是在室外…

免費下載：超音波感測器技術指南

台灣倍加福有限公司
信義路5段150巷2號21樓之4
信義區
11059 台北市臺灣
臺灣
fa-info@tw.pepperl-fuchs.com
phone +886 2 27227708

Pepperl+Fuchs 倍加福是領先全球的電子感測器 和 零組件的開發與製造商. 超過七十年的不斷創新、穩定的品質與持續的業績增長，成就了今日的我們， Pepperl+Fuchs 倍加福在全球擁有 6,300 名員工，並在德國、美國、新加坡、匈牙利、印尼和越南都設有製造工廠，其中多數工廠已通過 ISO 9001 認證