Power Supply PS1000-A6-24.10.R
- 100 V AC to 240 V AC wide-range input
- Output 24 V DC, 10 A, 240 W, 1-phase
- Housing width 39 mm
- Built-in decoupling mosfet for 1+1 and N+1 redundancy
- Efficiency up to 94.7 %
- Minimal inrush current surge
- DC OK relay contact
- Current sharing for parallel use
- Suitable for Zone 2/Div. 2 mounting
Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
Stáhněte si kompletní katalogový list ve formátu PDF:
Výňatek z katalogového listu: Technická data PS1000-A6-24.10.R
| Electrical specifications | ||
|---|---|---|
| Efficiency | 93 % at 120 V AC 94.7 % at 230 V AC |
|
| Power dissipation | 18.1 W at 120 V AC 13.4 W at 230 V AC |
|
| Input | ||
| Voltage range | 100 ... 240 V AC (-15 %/+10 %), 50 ... 60 Hz (±6 %) 110 ... 150 V DC (±20 %) |
|
| Current | 2.17 A at 120 V AC 1.14 A at 230 V AC 2.35 A at 110 V DC for lower output currents see technical information |
|
| Inrush current | 6 A peak at 120 V AC and ambient temperature 40 °C (104 °F) 9 A peak at 230 V AC and ambient temperature 40 °C (104 °F) |
|
| Capacity factor | 0.99 at 120 V AC 0.97 at 230 V AC |
|
| Output | ||
| Rated voltage | 24 V DC | |
| Voltage range | 23.8 ... 25.2 V DC factory setting: 24.1 V |
|
| Rated current | 10 A | |
| Current | 12 A at ambient temperature < 45 °C (113 °F) 10 A at ambient temperature 60 °C (140 °F) 7.5 A at ambient temperature 70 °C (158 °F) linear power derating see technical information |
|
| Power | 240 W | |
| Ripple | max. 50 mV pp | |
| Hold-up time | 37 ms at 120 V AC 37 ms at 230 V AC |
|
| Overload behavior | continuous current : output voltage > 13 V DC intermittent current : output voltage < 13 V DC |
|
| Short-circuit current | typ. 14 A , intermitted current peak value for typ. 2 s, load impedance < 10 mΩ | |
| Voltage limitation | typ. 30.5 V DC max. 32 V DC |
|
| Fault indication output | ||
| Connection | terminals 13, 14 | |
| Output type | relay contact DC OK - contact is closed if the output voltage is > 90 % of the adjusted output voltage |
|
| Contact loading | max. 60 V DC/0.3 A ; 30 V DC/1 A ; 30 V AC/0.5 A resistive load min. 1 mA at 5 V DC |
|
| Galvanic isolation | ||
| Input/Output | SELV/PELV | |
| Indicators/settings | ||
| Display elements | LED green: status DC OK - LED lights up if the output voltage is > 90 % of the adjusted output voltage |
|
| Directive conformity | ||
| Electromagnetic compatibility | ||
| Directive 2014/30/EU | IEC/EN 61000-6-1 , IEC/EN 61000-6-2 , IEC/EN 61000-6-3 , IEC/EN 61000-6-4 , IEC/EN 61000-3-2 , IEC/EN 61000-3-3 |
|
| Low voltage | ||
| Directive 2014/35/EU | EN 61010-1 | |
| RoHS | ||
| Directive 2011/65/EU (RoHS) | IEC/EN 63000:2019 | |
| Conformity | ||
| Degree of protection | EN 60529 | |
| Shock resistance | EN 60068-2-27 | |
| Vibration resistance | EN 60068-2-6 | |
| Ambient conditions | ||
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) , see technical information | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Relative humidity | 5 ... 95 %, noncondensing | |
| Shock resistance | 20 g , 11 ms or 30 g , 6 ms | |
| Vibration resistance | 2 ... 17.8 Hz : ± 1.6 mm , 17.8 ... 500 Hz : 2 g | |
| Mechanical specifications | ||
| Housing material | aluminum alloy , galvanized steel | |
| Degree of protection | IP20 | |
| Connection | ||
| Input/Output | plug-in connector with screw terminals conductor cross section: max. 4 mm2 (AWG 20-12) cable diameter: max. 2.4 mm, wire end ferrules included stripped insulation length: 7 mm tightening torque: max. 0.5 Nm |
|
| Relay contact output | plug-in connector with screw terminals conductor cross section: max. 1.5 mm2 (AWG 26-14) cable diameter: max. 1.8 mm, wire end ferrules included stripped insulation length: 6 mm tightening torque: max. 0.8 Nm |
|
| Mass | approx. 600 g | |
| Dimensions | 39 x 124 x 117 mm (W x H x D) , without plugs and without DIN mounting rail | |
| Height | 124 mm | |
| Width | 39 mm | |
| Depth | 117 mm | |
| Mounting | on 35 mm DIN mounting rail acc. to EN 60715:2001 | |
| Data for application in connection with hazardous areas | ||
| ATEX approval | ||
| ATEX certificate | EPS 15 ATEX 1101 X | |
| ATEX marking |  II 3G Ex ec nC II T4 Gc |
|
| Directive conformity | ||
| Directive 2014/34/EU | EN 60079-0:2012+A11:2013 , EN 60079-7:2015+A1:2018 , EN 60079-15:2010 | |
| International approvals | ||
| UL approval | E350173 , E223176 | |
| IECEx approval | ||
| IECEx certificate | IECEx EPS 20.0055X | |
| IECEx marking | Ex ec nC IIC T4 Gc | |
| Standards | IEC 60079-0:2017 , IEC 60079-7:2017 , IEC 60079-15:2017 | |
| General information | ||
| Supplementary information | Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com. | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27040790 |
| ECLASS 12.0 | 27040790 |
| ECLASS 11.0 | 27040790 |
| ECLASS 10.0.1 | 27040790 |
| ECLASS 9.0 | 27040790 |
| ECLASS 8.0 | 27049090 |
| ECLASS 5.1 | 27049090 |
| ETIM 9.0 | EC002542 |
| ETIM 8.0 | EC002542 |
| ETIM 7.0 | EC002542 |
| ETIM 6.0 | EC002542 |
| ETIM 5.0 | EC002542 |
| UNSPSC 12.1 | 39121004 |
Details: PS1000-A6-24.10.R
Informative Literature: PS1000-A6-24.10.R
| Literature | Jazyk | Typ souboru | Velikost souboru |
|---|---|---|---|
| Product Information - PS1000 for Global Use up to Zone 2/Div. 2 | ENG | 577 KB |
Product Documentation: PS1000-A6-24.10.R
| Product information | Jazyk | Typ souboru | Velikost souboru |
|---|---|---|---|
| Technical information | ENG | 4760 KB | |
| Safety and Security Documentation | |||
| Instruction manual / Betriebsanleitung | ALL | 243 KB | |
| Instruction manual / Betriebsanleitung | ALL | 305 KB | |
Design / Simulation: PS1000-A6-24.10.R
| CAD | Jazyk | Typ souboru | Velikost souboru |
|---|---|---|---|
| CAD 3-D / CAD 3-D | ALL | STP | 4716 KB |
| CAD Portal / CAD Portal | ALL | LINK | --- |
| CAE | |||
| CAE EPLAN macro EDZ / CAE EPLAN Makro EDZ | ALL | EDZ | 177 KB |
Approvals: PS1000-A6-24.10.R
| Certificates | Číslo certifikátu | Jazyk | Typ souboru | Velikost souboru |
|---|---|---|---|---|
| Bureau Veritas IECEx Certificate of Conformity | IECEx EPS 20.0055X | ALL | LINK | --- |
| Canada US UL | UL E350173 (NRAD/NRAD7) | ALL | 83 KB | |
| China SITIIAS CCC Ex Certificate | 2023122303116292 (Mannheim) | ALL | 529 KB | |
| Europe Bureau Veritas ATEX Category 3 G | EPS 15 ATEX 1 101 X | ALL | 1071 KB | |
| US CA UL | CoC E223176 RptRef E223176-20070416 | ALL | 444 KB | |
| Declaration of Conformity | ||||
| EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F) | DOC-4787 | ALL | 73 KB | |
| EU Declaration of Conformity (P+F) | TDOC-4787ACZE | CZE | 186 KB | |
Pepperl+Fuchs s.r.o.
Pod Vodárenskou věží 4
18208 Praha 8
Czech Republic
info@cz.pepperl-fuchs.com
+420 225 989 180
© 2024 Všechna práva vyhrazena
Pepperl+Fuchs je přední vývojář a výrobce průmyslových senzorů a komponentů pro světový trh automatizace. Neustálé inovace, trvalé kvalitní a stálý růst zaručuje mnoho úspěchů přes více než 70 let. Pepperl+Fuchs zaměstnává 6300 lidí po celém světě a má výrobní závody v Německu, USA, Singapuru, Maďarsku, Indonésii a Vietnamu, které podléhají ISO 9001.