Digital Output FB6210BR

4-channel
Outputs Ex ia
Installation in suitable enclosures in Zone 1
Module can be exchanged under voltage (hot swap)
Line fault detection (LFD)
Positive or negative logic selectable
Simulation mode for service operations (forcing)
Permanently self-monitoring
Output with watchdog

Technical Data
Informative Literature
Product Documentation
Approvals
お問い合わせ

注: Pepperl+Fuchs GmbH(旧社名)で発行された証明書・適合宣言書などすべての製品関連文書は、Pepperl+Fuchs AG(新社名)にそのまま適用されます。

データシート(PDF):

技術データ FB6210BR

Slots
Occupied slots		2
Supply
Connection		backplane bus / 24 V booster via wire ends
Rated voltage		12 V DC , only in connection with the power supplies FB92**
Input voltage range		18.5 ... 32 V DC (SELV/PELV) booster voltage
Power dissipation		3 W
Power consumption		0.15 W
Internal bus
Connection		backplane bus
Interface		manufacturer-specific bus to standard com unit
Digital output
Number of channels		4
Suitable field devices
	Field device	Solenoid Valve
	Field device [2]	audible alarm
	Field device [3]	visual alarm
Connection		channel I: 9+, 10-; channel II: 11+, 12-; channel III: 13+, 14-; channel IV: 15+, 16-
Internal resistor		max. 370 Ω
Current limit		37 mA
Open loop voltage		24.5 V
Line fault detection		can be switched on/off for each channel via configuration tool also when turned off (every 2.5 s the valve is turned on for 2 ms)
	Short-circuit	< 100 Ω
	Open-circuit	> 15 kΩ
Response time		10 ms (depending on bus cycle time)
Watchdog		within 0.5 s the device goes in safe state, e.g. after loss of communication
Reaction time		10 s
Indicators/settings
LED indication		LED green: supply LED red: line fault , red flashing: communication error
Coding		optional mechanical coding via front socket
Directive conformity
Electromagnetic compatibility
	Directive 2014/30/EU	EN 61326-1
Conformity
Electromagnetic compatibility		NE 21
Degree of protection		IEC 60529
Environmental test		EN 60068-2-14
Shock resistance		EN 60068-2-27
Vibration resistance		EN 60068-2-6
Damaging gas		EN 60068-2-42
Relative humidity		EN 60068-2-78
Ambient conditions
Ambient temperature		-20 ... 60 °C (-4 ... 140 °F)
Storage temperature		-25 ... 85 °C (-13 ... 185 °F)
Relative humidity		95 % non-condensing
Shock resistance		shock type I, shock duration 11 ms, shock amplitude 15 g, number of shocks 18
Vibration resistance		frequency range 10 ... 150 Hz; transition frequency: 57.56 Hz, amplitude/acceleration ± 0.075 mm/1 g; 10 cycles frequency range 5 ... 100 Hz; transition frequency: 13.2 Hz amplitude/acceleration ± 1 mm/0.7 g; 90 minutes at each resonance
Damaging gas		designed for operation in environmental conditions acc. to ISA-S71.04-1985, severity level G3
Mechanical specifications
Degree of protection		IP20 (module) , a separate housing is required acc. to the system description
Connection		removable front connector with screw flange (accessory) wiring connection via spring terminals (0.14 ... 1.5 mm²) or screw terminals (0.08 ... 1.5 mm²)
Mass		approx. 750 g
Dimensions		57 x 107 x 132 mm (2.2 x 4.2 x 5.2 inch)
Data for application in connection with hazardous areas
EU-type examination certificate		PTB 97 ATEX 1074 U
	Marking	II 2(1) G Ex d [ia Ga] IIC Gb II (1) D [Ex ia Da] IIIC
Output
	Voltage	27.8 V
	Current	90.4 mA
	Power	629 mW
	Internal capacitance	2.5 nF
	Internal inductance	0 mH
Galvanic isolation
	Output/power supply, internal bus	safe electrical isolation acc. to EN 60079-11, voltage peak value 375 V
Directive conformity
	Directive 2014/34/EU	EN 60079-0:2009 EN 60079-1:2007 EN 60079-11:2007 EN 60079-26:2007 EN 61241-11:2006
International approvals
ATEX approval		PTB 97 ATEX 1075 ; PTB 97 ATEX 1074 U
EAC approval		Russia: RU C-IT.MIII06.B.00129
Marine approval
	Lloyd Register	15/20021
	DNV GL Marine	TAA0000034
	American Bureau of Shipping	T1450280/UN
	Bureau Veritas Marine	22449/B0 BV
General information
System information		The module has to be mounted in appropriate backplanes and housings (FB92**) in Zone 1, 2, 21, 22 or outside hazardous areas (gas or dust). Here, observe the corresponding EC-type examination certificate.
Supplementary information		EC-Type Examination Certificate, Statement of Conformity, Declaration of Conformity, Attestation of Conformity and instructions have to be observed where applicable. For information see www.pepperl-fuchs.com.

Classifications

System	Classcode
ECLASS 13.0	27210101
ECLASS 12.0	27210101
ECLASS 11.0	27210101
ECLASS 10.0.1	27210101
ECLASS 9.0	27210101
ECLASS 8.0	27210101
ECLASS 5.1	27210120
ETIM 9.0	EC001485
ETIM 8.0	EC001485
ETIM 7.0	EC001485
ETIM 6.0	EC001485
ETIM 5.0	EC001485
UNSPSC 12.1	39121008

Details: FB6210BR

Informative Literature: FB6210BR

Literature	言語	ファイルタイプ	ファイルサイズ
Application Report - Communication Redundancy for Uninterrupted Operation	ENG	PDF	529 KB
Application Report - LB and FB Remote I/O Systems for Digitally Connecting Analog Field Devices	ENG	PDF	208 KB
Application Report - Space Saving Extension for Existing Plants	ENG	PDF	300 KB
Application Report - Using Remote I/O Systems for the Efficient Digitalization of Plants	ENG	PDF	371 KB
Selection table - Solenoid driver/valve combinations	ENG	PDF	299 KB

Product Documentation: FB6210BR

Safety and Security Documentation	言語	ファイルタイプ	ファイルサイズ
Instruction manual	ENG	PDF	148 KB
Functional Safety Manual	ENG	PDF	2364 KB
Manuals
Hardware Manual FB-Remote-I/O-System	ENG	PDF	9157 KB

Approvals: FB6210BR

Certificates	認証番号	言語	ファイルタイプ	ファイルサイズ
Bureau Veritas (Maritime) Marine	22449/C0 BV	ALL	PDF	590 KB
DNV Marine	TAA0000034	ALL	PDF	110 KB
Europe PTB ATEX Category 2 G	PTB 97 ATEX 1074U	ALL	PDF	2619 KB
Lloyd's Register Marine	LR2003616TA-02	ALL	PDF	557 KB
Declaration of Conformity
EU Declaration of Conformity (P+F)	TDOC-1057DENG	ENG	PDF	1142 KB