Power Supply PS1000-A6-24.20
- 100 V AC to 240 V AC wide-range input
- Output 24 V DC, 20 A, 480 W, 1-phase
- Housing width 48 mm
- Efficiency up to 95.6 %
- Minimal inrush current surge
- DC OK relay contact
- Current sharing for parallel use
- Suitable for Zone 2/Div. 2 mounting
注: Pepperl+Fuchs GmbH(旧社名)で発行された証明書・適合宣言書などすべての製品関連文書は、Pepperl+Fuchs AG(新社名)にそのまま適用されます。
データシート(PDF):
技術データ PS1000-A6-24.20
| Electrical specifications | ||
|---|---|---|
| Efficiency | 94.2 % at 120 V AC 95.6 % at 230 V AC |
|
| Power dissipation | 29.6 W at 120 V AC 22.1 W at 230 V AC |
|
| Input | ||
| Voltage range | 100 ... 240 V AC (-15 %/+10 %), 50 ... 60 Hz (±6 %) 110 ... 150 V DC (±20 %) |
|
| Current | 4.26 A at 120 V AC 2.23 A at 230 V AC 4.64 A at 110 V DC for lower output currents see technical information |
|
| Inrush current | 10 A peak at 120 V AC, temperature independent 4.5 A peak at 230 V AC, temperature independent |
|
| Capacity factor | 0.99 at 120 V AC 0.98 at 230 V AC |
|
| Output | ||
| Rated voltage | 24 V DC | |
| Voltage range | 24 ... 28 V DC factory setting: 24.1 V |
|
| Rated current | 20 A | |
| Current | 24 ... 20.6 A at ambient temperature < 45 °C (113 °F) 20 ... 17.1 A at ambient temperature 60 °C (140 °F) 15 ... 13 A at ambient temperature 70 °C (158 °F) linear power derating see technical information |
|
| Power | 480 W | |
| Ripple | max. 50 mV pp | |
| Hold-up time | 32 ms at 120 V AC 32 ms at 230 V AC |
|
| Overload behavior | continuous current : output voltage > 13 V DC intermittent current : output voltage < 13 V DC |
|
| Short-circuit current | typ. 29 A intermitted current peak value for typ. 2 s | |
| Voltage limitation | typ. 30.5 V DC max. 32 V DC |
|
| Fault indication output | ||
| Connection | terminals 13, 14 | |
| Output type | relay contact DC OK - contact is closed if the output voltage is > 90 % of the adjusted output voltage |
|
| Contact loading | max. 60 V DC/0.3 A ; 30 V DC/1 A ; 30 V AC/0.5 A resistive load min. 1 mA at 5 V DC |
|
| Galvanic isolation | ||
| Input/Output | SELV/PELV | |
| Indicators/settings | ||
| Display elements | LED green: status DC OK - LED lights up if the output voltage is > 90 % of the adjusted output voltage |
|
| Control elements | potentiometer , plug-in jumper | |
| Configuration | setting of the output voltage via potentiometer setting of the operating mode - plug-in jumper plugged in: "parallel use" operating mode - plug-in jumper not plugged in: "single use" operating mode |
|
| Directive conformity | ||
| Electromagnetic compatibility | ||
| Directive 2014/30/EU | IEC/EN 61000-6-1 , IEC/EN 61000-6-2 , IEC/EN 61000-6-3 , IEC/EN 61000-6-4 , IEC/EN 61000-3-2 , IEC/EN 61000-3-3 |
|
| Low voltage | ||
| Directive 2014/35/EU | EN 61010-1 | |
| RoHS | ||
| Directive 2011/65/EU (RoHS) | IEC/EN 63000:2019 | |
| Conformity | ||
| Degree of protection | EN 60529 | |
| Shock resistance | EN 60068-2-27 | |
| Vibration resistance | EN 60068-2-6 | |
| Ambient conditions | ||
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) , see technical information | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Relative humidity | 5 ... 95 %, noncondensing | |
| Shock resistance | 20 g , 11 ms or 30 g , 6 ms | |
| Vibration resistance | 2 ... 17.8 Hz : ± 1.6 mm , 17.8 ... 500 Hz : 2 g | |
| Corrosion resistance | IEC 60068-2-60, Method 4 ISA-71.04, severity level G3 |
|
| Mechanical specifications | ||
| Housing material | aluminum alloy , galvanized steel | |
| Degree of protection | IP20 | |
| Connection | ||
| Input/Output | screw terminals conductor cross section: max. 6 mm2 (AWG 20-10) cable diameter: max. 2.8 mm, wire end ferrules included stripped insulation length: 7 mm tightening torque: max. 1 Nm |
|
| Relay contact output | spring terminals with push-in connection technology conductor cross section: max. 1.5 mm2 (AWG 24-16) cable diameter: max. 1.6 mm, wire end ferrules included stripped insulation length: 7 mm |
|
| Mass | approx. 830 g | |
| Dimensions | 48 x 124 x 127 mm , without plugs and without DIN mounting rail | |
| Height | 124 mm | |
| Width | 48 mm | |
| Depth | 127 mm | |
| Mounting | on 35 mm DIN mounting rail acc. to EN 60715:2001 | |
| Data for application in connection with hazardous areas | ||
| ATEX approval | ||
| ATEX certificate | EPS 17 ATEX 1 089 X | |
| ATEX marking |  II 3G Ex ec nC II T4 Gc |
|
| Directive conformity | ||
| Directive 2014/34/EU | EN 60079-0:2012+A11:2013 , EN 60079-7:2015 , EN 60079-15:2010 | |
| International approvals | ||
| UL approval | E350173 , E223176 | |
| IECEx approval | ||
| IECEx certificate | IECEx EPS 20.0056X | |
| IECEx marking | Ex ec nC IIC T4 Gc | |
| Standards | IEC 60079-0:2011 , IEC 60079-7:2015 , IEC 60079-15:2010 | |
| General information | ||
| Supplementary information | Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com. | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27040790 |
| ECLASS 12.0 | 27040790 |
| ECLASS 11.0 | 27040790 |
| ECLASS 10.0.1 | 27040790 |
| ECLASS 9.0 | 27040790 |
| ECLASS 8.0 | 27049090 |
| ECLASS 5.1 | 27049090 |
| ETIM 9.0 | EC002542 |
| ETIM 8.0 | EC002542 |
| ETIM 7.0 | EC002542 |
| ETIM 6.0 | EC002542 |
| ETIM 5.0 | EC002542 |
| UNSPSC 12.1 | 39121004 |
Details: PS1000-A6-24.20
Informative Literature: PS1000-A6-24.20
| Literature | 言語 | ファイルタイプ | ファイルサイズ |
|---|---|---|---|
| Product Information - PS1000 for Global Use up to Zone 2/Div. 2 | ENG | 577 KB |
Product Documentation: PS1000-A6-24.20
| Product information | 言語 | ファイルタイプ | ファイルサイズ |
|---|---|---|---|
| Technical information | ENG | 4577 KB | |
| Safety and Security Documentation | |||
| Instruction manual / Betriebsanleitung | ALL | 243 KB | |
| Instruction manual / Betriebsanleitung | ALL | 307 KB | |
Design / Simulation: PS1000-A6-24.20
| CAD | 言語 | ファイルタイプ | ファイルサイズ |
|---|---|---|---|
| CAD 3-D / CAD 3-D | ALL | STP | 6363 KB |
| CAD Portal / CAD Portal | ALL | LINK | --- |
| CAE | |||
| CAE EPLAN macro EDZ / CAE EPLAN Makro EDZ | ALL | EDZ | 200 KB |
Approvals: PS1000-A6-24.20
| Certificates | 認証番号 | 言語 | ファイルタイプ | ファイルサイズ |
|---|---|---|---|---|
| Bureau Veritas IECEx Certificate of Conformity | IECEx EPS 20.0056X | ALL | LINK | --- |
| Canada US UL | UL E350173 (NRAD/NRAD7) | ALL | 83 KB | |
| Europe Bureau Veritas ATEX Category 3 G | EPS 17 ATEX 1 089X | ALL | 1041 KB | |
| Declaration of Conformity | ||||
| EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F) | DOC-4789 | ALL | 73 KB | |
| EU Declaration of Conformity (P+F) | TDOC-4789AENG | ENG | 185 KB | |
関連製品: PS1000-A6-24.20
| Accessories | ||||||
|---|---|---|---|---|---|---|
|
||||||
株式会社 ピーアンドエフ
〒220-0022
神奈川県横浜市西区花咲町6-145
横浜花咲ビル5F 日本
日本
sales@jp.pepperl-fuchs.com
+81 45 6249077
株式会社ピーアンドエフ
大阪府豊中市新千里東町1-5-3
千里朝日阪急ビル15階
〒560-0082 大阪
日本
sales@jp.pepperl-fuchs.com
+81 6 6836-5620
© 2024 All Rights Reserved.
Pepperl+Fuchsはグローバルオートメーション市場向けにセンサや部品の開発を行っており、革新的かつ高品質な技術躍進のために日々努力を続けています。ドイツ・アメリカ・シンガポール・ハンガリー・インドネシア・ベトナムに生産拠点があり、すべての工場でISO9001認証を取得しています。