AS-Interface sensor/actuator module VBA-4E2A-G2-XE/E2

AS-Interface certificate
Degree of protection IP67
A/B node with extended addressing possibility for up to 62 nodes
Addressing jack
Flat cable connection with cable piercing technique, variable flat cable guide
Communication monitoring
Inputs for 3-wire sensors (PNP) and mechanical contacts
Power supply of the inputs and outputs from the external auxiliary voltage
Ground connection (FE) possible
Function display for bus, ext. auxiliary voltage, inputs and outputs
Detection of output overload

Technical Data
Product Documentation
Design / Simulation
Approvals
関連製品
お問い合わせ

注: Pepperl+Fuchs GmbH(旧社名)で発行された証明書・適合宣言書などすべての製品関連文書は、Pepperl+Fuchs AG(新社名)にそのまま適用されます。

データシート(PDF):

技術データ VBA-4E2A-G2-XE/E2

型番
G2 flat module 4 inputs and 2 electronic outputs

General specifications
Node type		A/B node
AS-Interface specification		V2.1
Required gateway specification		≥ V2.1
UL File Number		E223772
Indicators/operating means
LED FAULT		error display; LED red red: communication error or address is 0 red flashing: overload of outputs
LED PWR		AS-Interface voltage; LED green
LED AUX		ext. auxiliary voltage U_AUX; LED green
LED IN		switching state (input); 4 LED yellow
LED OUT		Switching state (output); 2 LED yellow
Electrical specifications
Auxiliary voltage (output)		20 ... 30 V DC PELV
Rated operating voltage		26.5 ... 31.6 V from AS-Interface
Rated operating current		≤ 30 mA
Protection class		III
Current loading capacity		2 A (I_AUX)
Surge protection		U_AUX, U_in: Over voltage category III, safe isolated power supplies (PELV)
Input
Number/Type		4 inputs for mechanical contacts or 3-wire sensors (PNP), DC
Supply		from external auxiliary voltage U_AUX
Input current		3 mA (typically)
Switching point		according to DIN EN 61131-2 (type 1)
	0 (unattenuated)	≤ 0.5 mA
	1 (attenuated)	≥ 2 mA
Signal delay		< 2 ms (input/AS-Interface)
Signal frequency		≤ 250 Hz
Output
Number/Type		2 electronic outputs, PNP, overload and short-circuit proof
Supply		from external auxiliary voltage U_AUX
Voltage		≥ (U_AUX - 0.5 V)
Current		1 A per output , 2 A per module
Usage category		DC-13
Galvanic isolation
Input/Output		none
Input/AS-Interface		Basic insulation, rated insulation voltage 120 V DC
Output/AS-Interface		Basic insulation, rated insulation voltage 120 V DC
Directive conformity
Electromagnetic compatibility		observe notices on the certificate of conformity.
	Directive 2014/30/EU	EN 62026-2:2013
Standard conformity
Galvanic isolation		EN 60947-1:2007
Degree of protection		EN 60529:2000
Mech. capacity		EN 60068-2-6:2008, EN 60068-2-27:1995
Input		EN 61131-2:2007
Usage category		EN 60947-5-1:2005
Emitted interference		EN 61000-6-4:2001
AS-Interface		EN 62026-2:2013
Noise immunity		EN 61326-1:2006
Programming instructions
Profile		S-7.A.E
IO code		7
ID code		A
ID1 code		7
ID2 code		E
Data bits (function via AS-Interface)		InputOutput
	D0	IN1 O1
	D1	IN2 O2
	D2	IN3 -
	D3	IN4 -
Parameter bits (programmable via AS-i)		function
	P0	not used
	P1	not used
	P2	not used
	P3	not used
Ambient conditions
Ambient temperature		-25 ... 60 °C (-13 ... 140 °F)
Storage temperature		-25 ... 85 °C (-13 ... 185 °F)
Relative humidity		85 % , noncondensing
Climatic conditions		For indoor use only
Altitude		≤ 2000 m above MSL
Pollution degree		3
Mechanical specifications
Degree of protection		IP67
Connection		Cable piercing method flat cable yellow/flat cable black inputs/outputs: M12 round connector
Material
	Housing	PBT
Mass		approx. 100 g
Tightening torque, cable gland		0.4 Nm
Mounting		Mounting plate

Classifications

System	Classcode
ECLASS 13.0	27242604
ECLASS 12.0	27242604
ECLASS 11.0	27242604
ECLASS 10.0.1	27242604
ECLASS 9.0	27242604
ECLASS 8.0	27242604
ECLASS 5.1	27242604
ETIM 9.0	EC001599
ETIM 8.0	EC001599
ETIM 7.0	EC001599
ETIM 6.0	EC001599
ETIM 5.0	EC001599
UNSPSC 12.1	39121535

Details: VBA-4E2A-G2-XE/E2

Product Documentation: VBA-4E2A-G2-XE/E2

Brief Instructions	言語	ファイルタイプ	ファイルサイズ
Instruction leaflet / Beipackzettel	ALL	PDF	188 KB

Design / Simulation: VBA-4E2A-G2-XE/E2

CAD	言語	ファイルタイプ	ファイルサイズ
CAD 3-D / CAD 3-D	ALL	STP	149 KB
CAD Portal / CAD Portal	ALL	LINK	---

Approvals: VBA-4E2A-G2-XE/E2

Certificates	認証番号	言語	ファイルタイプ	ファイルサイズ
Canada, USA UL	CoC 20141115-E223772	ALL	PDF	342 KB
Declaration of Conformity
EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F)	DOC-1018C	ALL	PDF	118 KB

関連製品: VBA-4E2A-G2-XE/E2

Matching System Components

	U-G3FF AS-Interface module mounting base
	AS-Interface module mounting base for connection to flat cable (AS-Interface and external auxiliary power)fa

Accessories

	VBP-HH1-V3.0-KIT AS-Interface Handheld with accessory
	AS-Interface Handheld with accessoryfa

	VAZ-PK-1,5M-V1-G Adapter cable module/hand-held programming device
	Adapter cable module/hand-held programming devicefa

General Notes Relating to Pepperl+Fuchs Product Information

Free Download: White Paper on TCP-Based Communication Protocols (PDF)

This free PDF white paper compares the different TCP-based communication protocols (AMQP, OPC UA, MQTT, REST API) that have found their way up and are considered the enablers of IIoT and Industry 4.0. Get your free download now!

AS-Interface Switch Cabinet Module KE5 – Simple Handling and Improved Manageability

The unique housing design of the new KE5 switch cabinet module enables distinct visibility and simplifies mounting, wiring, and maintenance inside switch cabinets and junction boxes.