Digital Output with Position Feedback LB2117E

1-channel
1 digital output, 2 digital inputs
Mounting in Zone 2, Class I/Div.2 or in the safe area
Inputs and output Ex ia
Line fault detection switched on and off
Positive or negative logic selectable
Simulation mode for service operations (forcing)
Permanently self-monitoring
Output with watchdog
Output with bus-independent safety shutdown
Module can be exchanged under voltage

Technical Data
Informative Literature
Product Documentation
Design / Simulation
Approvals
관련문서
전문가 상담

Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.

PDF 파일로 된 데이타 시트 다운로드:

데이타 시트 발췌: 기술 사양 LB2117E

Slots
Occupied slots		1
Supply
Connection		backplane bus
Rated voltage		Use only in connection with the power supplies LB9***
Power dissipation		1.3 W
Power consumption		1.85 W
Internal bus
Connection		backplane bus
Interface		manufacturer-specific bus to standard com unit
Digital input
Number of channels		2
Sensor interface
	Connection	NAMUR sensor
	Connection [2]	volt-free contact
Connection		channel I: 2+, 5-; channel II: 3+, 6-
Rated values		acc. to EN 60947-5-6 (NAMUR)
Switching point/switching hysteresis		1.2 ... 2.1 mA / ± 0.2 mA
Voltage		8.2 V
Internal resistor		1 kΩ
Line fault detection		can be switched on/off for each channel via configuration tool
	Connection	mechanical switch with additional resistors (see connection diagram) proximity sensors without additional wiring
	Short-circuit	< 360 Ω
	Open-circuit	< 0.35 mA
Minimum pulse duration		1 ms
Digital output
Number of channels		1
Suitable field devices
	Field device	Solenoid Valve
	Field device [2]	audible alarm
	Field device [3]	visual alarm
Connection		channel I: 1+, 4-
Internal resistor		131 Ω
Current limit		50 mA
Open loop voltage		16.5 V
Line fault detection		can be switched on/off for each channel via configuration tool , also when turned off (every 2.5 s the valve is turned on for 2 ms)
	Short-circuit	< 50 Ω
	Open-circuit	> 10 kΩ
Response time		10 ms (depending on bus cycle time)
Watchdog		within 0.5 s the device goes in safe state, e.g. after loss of communication
Indicators/settings
LED indication		Power LED (P) green: supply Diagnostic LED (I) red: module fault , red flashing: communication error , white: fixed parameter set (parameters from com unit are ignored) , white flashing: requests parameters from com unit Status LED (O: output, I1: input 1, I2: input 2) red: line fault (lead breakage or short circuit) , yellow: state of digital I/O (0/1)
Coding		optional mechanical coding via front socket
Directive conformity
Electromagnetic compatibility
	Directive 2014/30/EU	EN 61326-1:2013
Conformity
Electromagnetic compatibility		NE 21
Degree of protection		IEC 60529
Environmental test		EN 60068-2-14
Shock resistance		EN 60068-2-27
Vibration resistance		EN 60068-2-6
Damaging gas		EN 60068-2-42
Relative humidity		EN 60068-2-78
Ambient conditions
Ambient temperature		-40 ... 60 °C (-40 ... 140 °F)
Storage temperature		-40 ... 85 °C (-40 ... 185 °F)
Relative humidity		95 % non-condensing
Altitude		max. 2000 m
Shock resistance		shock type I, shock duration 11 ms, shock amplitude 15 g, number of shocks 18
Vibration resistance		frequency range 10 ... 150 Hz; transition frequency: 57.56 Hz, amplitude/acceleration ± 0.075 mm/1 g; 10 cycles frequency range 5 ... 100 Hz; transition frequency: 13.2 Hz amplitude/acceleration ± 1 mm/0.7 g; 90 minutes at each resonance
Damaging gas		designed for operation in environmental conditions acc. to ISA-S71.04-1985, severity level G3
Mechanical specifications
Degree of protection		IP20 when mounted on backplane
Connection		removable front connector with screw flange (accessory) wiring connection via spring terminals (0.14 ... 1.5 mm²) or screw terminals (0.08 ... 1.5 mm²)
Mass		approx. 110 g
Dimensions		16 x 100 x 102 mm (0.63 x 3.9 x 4 inch)
Data for application in connection with hazardous areas
EU-type examination certificate		EXA 16 ATEX 0025X
	Marking	II 3(1) G Ex nA [ia Ga] IIC T4 Gc II (1) D [Ex ia Da] IIIC I (M1) [Ex ia Ma] I
Input
	Voltage	10 V
	Current	13 mA
	Power	33 mW (linear characteristic)
	Internal capacitance	1.2 nF
	Internal inductance	0 mH
Output
	Voltage	17.8 V
	Current	162 mA
	Power	751 mW
	Internal capacitance	12 nF
	Internal inductance	0 mH
Galvanic isolation
	Input/power supply, internal bus	safe electrical isolation acc. to EN 60079-11, voltage peak value 375 V
	Output/power supply, internal bus	safe electrical isolation acc. to EN 60079-11, voltage peak value 375 V
Directive conformity
	Directive 2014/34/EU	EN IEC 60079-0:2018+AC:2020 EN 60079-11:2012 EN 60079-15:2010
International approvals
ATEX approval		EXA 16 ATEX 0025X
UL approval		E106378
	Control drawing	116-0426 (cULus)
IECEx approval		IECEx EXA 16.0010X
	Approved for	Ex nA [ia Ga] IIC T4 Gc [Ex ia Da] IIIC [Ex ia Ma] I
General information
System information		The module has to be mounted in appropriate backplanes (LB9***) in Zone 2 or outside hazardous areas. Here, observe the corresponding declaration of conformity. For use in hazardous areas (e. g. Zone 2, Zone 22 or Div. 2) the module must be installed in an appropriate enclosure.
Supplementary information		Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com.

Classifications

System	Classcode
ECLASS 13.0	27210101
ECLASS 12.0	27210101
ECLASS 11.0	27210101
ECLASS 10.0.1	27210101
ECLASS 9.0	27210101
ECLASS 8.0	27210101
ECLASS 5.1	27210120
ETIM 9.0	EC001485
ETIM 8.0	EC001485
ETIM 7.0	EC001485
ETIM 6.0	EC001485
ETIM 5.0	EC001485
UNSPSC 12.1	39121008

Details: LB2117E

Informative Literature: LB2117E

Literature	언어	파일 타입	파일 크기
Application Report - Communication Redundancy for Uninterrupted Operation	ENG	PDF	529 KB
Application Report - LB and FB Remote I/O Systems for Digitally Connecting Analog Field Devices	ENG	PDF	208 KB
Application Report - Space Saving Extension for Existing Plants	ENG	PDF	300 KB
Application Report - The Modern Whiskey Distillery	ENG	PDF	176 KB
Application Report - Use of Remote I/O in Fluidized Bed Systems	ENG	PDF	222 KB
Application Report - Using Remote I/O Systems for the Efficient Digitalization of Plants	ENG	PDF	371 KB
Selection table - Solenoid driver/valve combinations	ENG	PDF	299 KB

Product Documentation: LB2117E

Safety and Security Documentation	언어	파일 타입	파일 크기
Instruction manual	ENG	PDF	179 KB
Functional Safety Manual	ENG	PDF	2364 KB
Manuals
Hardware Manual LB-Remote-I/O-System	ENG	PDF	5385 KB

Design / Simulation: LB2117E

CAD	언어	파일 타입	파일 크기
CAD 3-D / CAD 3-D	ALL	STP	2082 KB
CAD Portal / CAD Portal	ALL	LINK	---

Approvals: LB2117E

Certificates	인증서 번호	언어	파일 타입	파일 크기
Canada UL cUL	E106378 cUL (QUZW7)	ALL	LINK	---
China SITIIAS CCC Ex Certificate	2021322310003621 (Singapore)	ALL	PDF	10583 KB
EXA Ex i and Ex n	IECEx EXA 16.0010X	ALL	LINK	---
Europe EXA ATEX Category (1) D ATEX Category 3 G	EXA 16 ATEX 0025X	ALL	PDF	366 KB
South Africa MASC	MASC MS/20-8438X	ALL	PDF	730 KB
USA Canada, USA UL Certificate of Compliance cULus	20161110-E106378	ALL	PDF	570 KB
USA UL	E106378 UL (QUZW)	ALL	LINK	---
United Kingdom CML UKEX Category (1) D UK-Type Examination Certificate UKEX Category (1) G UKEX Category 3 (1) G UKEX Category (M1)	CML 21UKEX2662X	ALL	PDF	187 KB
Control Drawings
Control drawing CSA / Control drawing CSA		ALL	PDF	320 KB
Declaration of Conformity
EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F)	DOC-2602C	ALL	PDF	1143 KB
UK Declaration of Conformity (P+F) / UK-Konformitäterklärung (P+F)	DOC-5791	ALL	PDF	1038 KB