Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
PDF 파일로 된 데이타 시트 다운로드:
Electrical specifications | ||
---|---|---|
Efficiency | 95.3 % at 3 x 400 V AC 95.2 % at 3 x 480 V AC |
|
Power dissipation | 47.3 W at 3 x 400 V AC 48.4 W at 3 x 480 V AC |
|
Input | ||
Voltage range | 3x 380 ... 480 V AC (-15 %/+20 %), 50 ... 60 Hz (±6 %) | |
Current | 1.65 A at 3 x 400 V AC 1.35 A at 3 x 480 V AC for lower output currents see technical information |
|
Inrush current | 4.5 A peak at 3 x 400 V AC, temperature-independent 4.5 A peak at 3 x 480 V AC , temperature-independent |
|
Capacity factor | 0.88 at 3 x 400 V AC 0.9 at 3 x 480 V AC |
|
Remote control | terminals 15, 16 remote control for ON/OFF and shutdown input |
|
Output | ||
Rated voltage | 24 V DC | |
Voltage range | 24 ... 28 V DC factory setting: 24.1 V |
|
Rated current | 40 A | |
Current | continuous: 40 ... 34.3 A short-term up to 4 s: 60 ... 51.5 A linear power derating see technical information |
|
Power | 960 W | |
Ripple | max. 100 mV pp | |
Hold-up time | 25 ms at 3 x 400 V AC 25 ms at 3 x 480 V AC |
|
Overload behavior | constant current mode | |
Short-circuit current | typ. 46 A continuous, load impedance < 10 mΩ | |
Voltage limitation | typ. 30.5 V DC max. 32 V DC |
|
Fault indication output | ||
Connection | terminals 13, 14 | |
Output type | relay contact DC OK - contact is closed if the output voltage is > 90 % of the adjusted output voltage |
|
Contact loading | max. 60 V DC/0.3 A ; 30 V DC/1 A ; 30 V AC/0.5 A resistive load min. 1 mA at 5 V DC |
|
Galvanic isolation | ||
Input/Output | SELV/PELV | |
Indicators/settings | ||
Display elements | LED green: status DC OK - LED lights up if the output voltage is > 90 % of the adjusted output voltage LED red: overload - LED lights up if the output voltage is < 90 % of the adjusted output voltage or in case of short circuit - flashes if the shutdown has been activated or if the device has shut down due to overtemperature |
|
Control elements | potentiometer , plug-in jumper | |
Configuration | setting of the output voltage via potentiometer setting of the operating mode - plug-in jumper plugged in: "parallel use" operating mode - plug-in jumper not plugged in: "single use" operating mode setting of the shutdown input: - plug-in jumper plugged in: device switches off |
|
Directive conformity | ||
Electromagnetic compatibility | ||
Directive 2014/30/EU | IEC/EN 61000-6-1 , IEC/EN 61000-6-2 , IEC/EN 61000-6-3 , IEC/EN 61000-6-4 , IEC/EN 61000-3-2 , IEC/EN 61000-3-3 |
|
Low voltage | ||
Directive 2014/35/EU | EN 61010-1 | |
RoHS | ||
Directive 2011/65/EU (RoHS) | IEC/EN 63000:2019 | |
Conformity | ||
Degree of protection | EN 60529 | |
Shock resistance | EN 60068-2-27 | |
Vibration resistance | EN 60068-2-6 | |
Ambient conditions | ||
Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) , see technical information | |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
Relative humidity | 5 ... 95 %, noncondensing | |
Shock resistance | 15 g , 6 ms or 10 g , 11 ms | |
Vibration resistance | 2 ... 17.8 Hz : ± 1.6 mm , 17.8 ... 500 Hz : 1 g | |
Mechanical specifications | ||
Housing material | aluminum alloy , galvanized steel | |
Degree of protection | IP20 | |
Connection | ||
Input | screw terminals conductor cross section: max. 6 mm2 (AWG 20-10) cable diameter: max. 2.8 mm, wire end ferrules included stripped insulation length: 7 mm tightening torque: max. 1 Nm |
|
Output | screw terminals conductor cross section: max. 16 mm2 (AWG 22-8) cable diameter: max. 5.2 mm, wire end ferrules included stripped insulation length: 12 mm tightening torque: max. 2.3 Nm |
|
Relay contact output | spring terminals conductor cross section: max. 1.5 mm2 (AWG 24-16) cable diameter: max. 1.6 mm, wire end ferrules included stripped insulation length: 7 mm |
|
Remote control/shutdown input | spring terminals conductor cross section: max. 1.5 mm2 (AWG 24-16) cable diameter: max. 1.6 mm, wire end ferrules included stripped insulation length: 7 mm |
|
Mass | approx. 1500 g | |
Dimensions | 110 x 124 x 127 mm (W x H x D) , without DIN mounting rail | |
Height | 124 mm | |
Width | 110 mm | |
Depth | 127 mm | |
Mounting | on 35 mm DIN mounting rail acc. to EN 60715:2001 | |
International approvals | ||
UL approval | E223176 | |
General information | ||
Supplementary information | Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com. |
System | Classcode |
---|---|
ECLASS 13.0 | 27040790 |
ECLASS 12.0 | 27040790 |
ECLASS 11.0 | 27040790 |
ECLASS 10.0.1 | 27040790 |
ECLASS 9.0 | 27040790 |
ECLASS 8.0 | 27049090 |
ECLASS 5.1 | 27049090 |
ETIM 9.0 | EC002542 |
ETIM 8.0 | EC002542 |
ETIM 7.0 | EC002542 |
ETIM 6.0 | EC002542 |
ETIM 5.0 | EC002542 |
UNSPSC 12.1 | 39121004 |
Literature | 언어 | 파일 타입 | 파일 크기 |
---|---|---|---|
Product Information - PS1000 for Global Use up to Zone 2/Div. 2 | ENG | 577 KB |
Product information | 언어 | 파일 타입 | 파일 크기 |
---|---|---|---|
Technical information | ENG | 2915 KB | |
Safety and Security Documentation | |||
Instruction manual / Betriebsanleitung | ALL | 307 KB |
CAD | 언어 | 파일 타입 | 파일 크기 |
---|---|---|---|
CAD 3-D / CAD 3-D | ALL | STP | 10238 KB |
CAD Portal / CAD Portal | ALL | LINK | --- |
CAE | |||
CAE EPLAN macro EDZ / CAE EPLAN Makro EDZ | ALL | EDZ | 211 KB |
Certificates | 인증서 번호 | 언어 | 파일 타입 | 파일 크기 |
---|---|---|---|---|
DNV GL Marine | TAA0000316 | ALL | 179 KB | |
US CA UL | CoC E223176 RptRef E223176-20070416 | ALL | 444 KB | |
Declaration of Conformity | ||||
EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F) | DOC-4791 | ALL | 79 KB | |
EU Declaration of Conformity (P+F) | TDOC-4791AENG | ENG | 177 KB |