General specifications |
Sensing range | 30 ... 300 mm |
Adjustment range | 50 ... 300 mm |
Dead band | 0 ... 30 mm |
Standard target plate | 100 mm x 100 mm |
Transducer frequency | approx. 380 kHz |
Response delay | 21 ms minimum 63 ms factory setting |
Indicators/operating means |
LED green | solid: Power-on flashing: Standby mode or program function object detected |
LED yellow 1 | solid: switching state switch output 1 flashing: program function |
LED yellow 2 | solid: switching state switch output 2 flashing: program function |
LED red | solid: temperature/program plug not connected flashing: fault or program function object not detected |
Temperature/teach-in connector | Temperature compensation , Switch points programming , output function setting |
Electrical specifications |
Operating voltage | 10 ... 30 V DC , ripple 10 %SS |
No-load supply current | ≤ 50 mA |
Interface |
Interface type | RS 232, 9600 Bit/s , no parity, 8 data bits, 1 stop bit |
Input/Output |
Synchronization | bi-directional 0 level -UB...+1 V 1 level: +4 V...+UB input impedance: > 12 KOhm synchronization pulse: ≥ 100 µs, synchronization interpulse period: ≥ 2 ms |
Synchronization frequency | |
| Common mode operation | max. 95 Hz |
| Multiplex operation | ≤ 95 Hz / n , n = number of sensors , n ≤ 5
|
Output |
Output type | 2 switch outputs PNP, NO/NC, programmable |
Rated operating current | 200 mA , short-circuit/overload protected |
Voltage drop | ≤ 2.5 V |
Repeat accuracy | ≤ 0.1 % of full-scale value |
Switching frequency | ≤ 7 Hz |
Range hysteresis | 1 % of the adjusted operating range (default settings), programmable |
Temperature influence | ≤ 2 % from full-scale value (with temperature compensation) ≤ 0.2 %/K (without temperature compensation) |
Compliance with standards and directives |
Standard conformity | |
| Standards | EN IEC 60947-5-2:2020 IEC 60947-5-2:2019 |
Approvals and certificates |
UL approval | cULus Listed, General Purpose |
CCC approval | CCC approval / marking not required for products rated ≤36 V |
Ambient conditions |
Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
Mechanical specifications |
Connection type | Connector plug M12 x 1 , 5-pin |
Degree of protection | sensor head: IP67 connector sensor head/controller unit: IP52 |
Material | |
| Housing | stainless steel (1.4305 / AISI 303) PBT plastic parts |
| Transducer | epoxy resin/hollow glass sphere mixture; polyurethane foam |
Mass | 210 g |
Dimensions | |
| Length | 25 mm |
| Diameter | 18 mm |
Factory settings |
Output 1 | Switching point: 60 mm output function: Switch point operation mode output behavior: NO contact |
Output 2 | Switching point: 500 mm output function: Switch point operation mode output behavior: NO contact |