Power Supply PS1000-A6-24.10.R
- 100 V AC to 240 V AC wide-range input
- Output 24 V DC, 10 A, 240 W, 1-phase
- Housing width 39 mm
- Built-in decoupling mosfet for 1+1 and N+1 redundancy
- Efficiency up to 94.7 %
- Minimal inrush current surge
- DC OK relay contact
- Current sharing for parallel use
- Suitable for Zone 2/Div. 2 mounting
Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
De complete datasheet als PDF downloaden:
Technische gegevens PS1000-A6-24.10.R
| Electrical specifications | ||
|---|---|---|
| Efficiency | 93 % at 120 V AC 94.7 % at 230 V AC |
|
| Power dissipation | 18.1 W at 120 V AC 13.4 W at 230 V AC |
|
| Input | ||
| Voltage range | 100 ... 240 V AC (-15 %/+10 %), 50 ... 60 Hz (±6 %) 110 ... 150 V DC (±20 %) |
|
| Current | 2.17 A at 120 V AC 1.14 A at 230 V AC 2.35 A at 110 V DC for lower output currents see technical information |
|
| Inrush current | 6 A peak at 120 V AC and ambient temperature 40 °C (104 °F) 9 A peak at 230 V AC and ambient temperature 40 °C (104 °F) |
|
| Capacity factor | 0.99 at 120 V AC 0.97 at 230 V AC |
|
| Output | ||
| Rated voltage | 24 V DC | |
| Voltage range | 23.8 ... 25.2 V DC factory setting: 24.1 V |
|
| Rated current | 10 A | |
| Current | 12 A at ambient temperature < 45 °C (113 °F) 10 A at ambient temperature 60 °C (140 °F) 7.5 A at ambient temperature 70 °C (158 °F) linear power derating see technical information |
|
| Power | 240 W | |
| Ripple | max. 50 mV pp | |
| Hold-up time | 37 ms at 120 V AC 37 ms at 230 V AC |
|
| Overload behavior | continuous current : output voltage > 13 V DC intermittent current : output voltage < 13 V DC |
|
| Short-circuit current | typ. 14 A , intermitted current peak value for typ. 2 s, load impedance < 10 mΩ | |
| Voltage limitation | typ. 30.5 V DC max. 32 V DC |
|
| Fault indication output | ||
| Connection | terminals 13, 14 | |
| Output type | relay contact DC OK - contact is closed if the output voltage is > 90 % of the adjusted output voltage |
|
| Contact loading | max. 60 V DC/0.3 A ; 30 V DC/1 A ; 30 V AC/0.5 A resistive load min. 1 mA at 5 V DC |
|
| Galvanic isolation | ||
| Input/Output | SELV/PELV | |
| Indicators/settings | ||
| Display elements | LED green: status DC OK - LED lights up if the output voltage is > 90 % of the adjusted output voltage |
|
| Directive conformity | ||
| Electromagnetic compatibility | ||
| Directive 2014/30/EU | IEC/EN 61000-6-1 , IEC/EN 61000-6-2 , IEC/EN 61000-6-3 , IEC/EN 61000-6-4 , IEC/EN 61000-3-2 , IEC/EN 61000-3-3 |
|
| Low voltage | ||
| Directive 2014/35/EU | EN 61010-1 | |
| RoHS | ||
| Directive 2011/65/EU (RoHS) | IEC/EN 63000:2019 | |
| Conformity | ||
| Degree of protection | EN 60529 | |
| Shock resistance | EN 60068-2-27 | |
| Vibration resistance | EN 60068-2-6 | |
| Ambient conditions | ||
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) , see technical information | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Relative humidity | 5 ... 95 %, noncondensing | |
| Shock resistance | 20 g , 11 ms or 30 g , 6 ms | |
| Vibration resistance | 2 ... 17.8 Hz : ± 1.6 mm , 17.8 ... 500 Hz : 2 g | |
| Mechanical specifications | ||
| Housing material | aluminum alloy , galvanized steel | |
| Degree of protection | IP20 | |
| Connection | ||
| Input/Output | plug-in connector with screw terminals conductor cross section: max. 4 mm2 (AWG 20-12) cable diameter: max. 2.4 mm, wire end ferrules included stripped insulation length: 7 mm tightening torque: max. 0.5 Nm |
|
| Relay contact output | plug-in connector with screw terminals conductor cross section: max. 1.5 mm2 (AWG 26-14) cable diameter: max. 1.8 mm, wire end ferrules included stripped insulation length: 6 mm tightening torque: max. 0.8 Nm |
|
| Mass | approx. 600 g | |
| Dimensions | 39 x 124 x 117 mm (W x H x D) , without plugs and without DIN mounting rail | |
| Height | 124 mm | |
| Width | 39 mm | |
| Depth | 117 mm | |
| Mounting | on 35 mm DIN mounting rail acc. to EN 60715:2001 | |
| Data for application in connection with hazardous areas | ||
| ATEX approval | ||
| ATEX certificate | EPS 15 ATEX 1101 X | |
| ATEX marking |  II 3G Ex ec nC II T4 Gc |
|
| Directive conformity | ||
| Directive 2014/34/EU | EN 60079-0:2012+A11:2013 , EN 60079-7:2015+A1:2018 , EN 60079-15:2010 | |
| International approvals | ||
| UL approval | E350173 , E223176 | |
| IECEx approval | ||
| IECEx certificate | IECEx EPS 20.0055X | |
| IECEx marking | Ex ec nC IIC T4 Gc | |
| Standards | IEC 60079-0:2017 , IEC 60079-7:2017 , IEC 60079-15:2017 | |
| General information | ||
| Supplementary information | Observe the certificates, declarations of conformity, instruction manuals, and manuals where applicable. For information see www.pepperl-fuchs.com. | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27040790 |
| ECLASS 12.0 | 27040790 |
| ECLASS 11.0 | 27040790 |
| ECLASS 10.0.1 | 27040790 |
| ECLASS 9.0 | 27040790 |
| ECLASS 8.0 | 27049090 |
| ECLASS 5.1 | 27049090 |
| ETIM 9.0 | EC002542 |
| ETIM 8.0 | EC002542 |
| ETIM 7.0 | EC002542 |
| ETIM 6.0 | EC002542 |
| ETIM 5.0 | EC002542 |
| UNSPSC 12.1 | 39121004 |
Details: PS1000-A6-24.10.R
Informative Literature: PS1000-A6-24.10.R
| Literature | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|
| Product Information - PS1000 for Global Use up to Zone 2/Div. 2 | ENG | 577 KB |
Product Documentation: PS1000-A6-24.10.R
| Product information | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|
| Technical information | ENG | 4760 KB | |
| Safety and Security Documentation | |||
| Instruction manual / Betriebsanleitung | ALL | 243 KB | |
| Instruction manual / Betriebsanleitung | ALL | 305 KB | |
Design / Simulation: PS1000-A6-24.10.R
| CAD | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|
| CAD 3-D / CAD 3-D | ALL | STP | 4716 KB |
| CAD Portal / CAD Portal | ALL | LINK | --- |
| CAE | |||
| CAE EPLAN macro EDZ / CAE EPLAN Makro EDZ | ALL | EDZ | 177 KB |
Approvals: PS1000-A6-24.10.R
| Certificates | Certificaatnummer | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|---|
| Bureau Veritas IECEx Certificate of Conformity | IECEx EPS 20.0055X | ALL | LINK | --- |
| Canada US UL | UL E350173 (NRAD/NRAD7) | ALL | 83 KB | |
| China SITIIAS CCC Ex Certificate | 2023122303116292 (Mannheim) | ALL | 529 KB | |
| Europe Bureau Veritas ATEX Category 3 G | EPS 15 ATEX 1 101 X | ALL | 1071 KB | |
| US CA UL | CoC E223176 RptRef E223176-20070416 | ALL | 444 KB | |
| Declaration of Conformity | ||||
| EU Declaration of Conformity (P+F) / EU-Konformitäterklärung (P+F) | DOC-4787 | ALL | 73 KB | |
| EU Declaration of Conformity (P+F) | TDOC-4787AHOL | HOL | 183 KB | |
Pepperl+Fuchs N.V.
Metropoolstraat 11
2900 Schoten / Anvers
BELGIË
BTW BE 0436.097.152, RPR Antwerpen, afd. Antw.
sales@be.pepperl-fuchs.com
+32 3 644 25 00
© 2024 Alle rechten voorbehouden.
Pepperl+Fuchs is een toonaangevend ontwikkelaar en producent van elektronische sensoren en componenten voor de wereldwijde automatiseringsmarkt. Continue innovatie, hoge kwaliteit en gestage groei zijn de basis van ons succes, al meer dan 70 jaar. Pepperl+Fuchs heeft wereldwijd 6300 medewerkers en productiefaciliteiten in Duitsland, de Verenigde Staten, Singapore, Hongarije, Indonesië en Vietnam, waarvan het merendeel ISO 9001 gecertificeerd.