I/O hub ICA-16DI-G16-IO
- IO-Link Class A
- IO-Link 1.1.4
- LED for switching state and fault indication
- Configuration and control via IO-Link
- Supply from IO-Link
- 16 digital inputs
Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
Pobierz pełną kartę katalogową w formie pliku PDF:
Dane techniczne ICA-16DI-G16-IO
| Opis produktu |
|---|
| I/O hub with IO-Link interface for 16 digital inputs |
| Indicators/operating means | ||
|---|---|---|
| LED PWR | LED green: flashing with short break (1 Hz) - IO-Link mode | |
| LED IO | Switch state (IO); multicolor LED yellow: only IO pin 4 is active blue: only IO pin 2 is active green: both IO pin 4 and pin 2 are active red: overload at sensor supply or output |
|
| Electrical specifications | ||
| Operating voltage | 18 ... 30 V DC, PELV Current limitation of the supply max. 4 A |
|
| No-load supply current | ≤ 25 mA | |
| Operating current | max. 4 A | |
| Interface | ||
| Interface type | IO-Link | |
| IO-Link revision | 1.1 | |
| Device profile | Identification and Diagnosis - I&D Firmware update |
|
| Process data | Inputs 3 Byte - Input signals 16 Bit - diagnosis signals 5 Bit |
|
| Vendor ID | 1 (0x0001) | |
| Device ID | 985857 (0x0F0B01) | |
| Data transfer rate | COM3 (230.4 kbits/s) | |
| Min. cycle time | 1 ms |
|
| SIO mode support | no | |
| Compatible master port type | Class A |
|
| Input | ||
| Number/Type | 16 Inputs for 3-wire sensors (PNP), DC (IN1 ... IN16) | |
| Supply | from IO-Link | |
| Current loading capacity | 180 mA , overload and short-circuit protected | |
| Input current | ≤ 5 mA (limited internally) | |
| Switching point | Type 3 according to IEC 61131-2 | |
| Directive conformity | ||
| Electromagnetic compatibility | ||
| Directive 2014/30/EU | EN 61326-1:2013 EN 55011:2016 |
|
| Conformity | ||
| Communication interface | IEC 61131-9:2013 | |
| Standard conformity | ||
| Degree of protection | EN 60529:2000 | |
| Fieldbus standard | EN 61131-9:2013 | |
| Input | EN 61131-2:2007 | |
| Communication interface | IEC 61131-9 / IO-Link V1.1.4 | |
| Emitted interference | EN 61000-6-4:2007 | |
| Noise immunity | EN 61000-6-2:2005, EN 61326-1:2006 | |
| Approvals and certificates | ||
| UL approval | Load specification DC General Use / DC Pilot Duty Degree of protection not tested by UL; tested by Pepperl+Fuchs SE |
|
| Ambient conditions | ||
| Ambient temperature | -30 ... 70 °C (-22 ... 158 °F) | |
| Storage temperature | -30 ... 70 °C (-22 ... 158 °F) | |
| Relative humidity | 85 % non-condensing | |
| Climatic conditions | For indoor use only | |
| Altitude | ≤ 5000 m above MSL | |
| Shock and impact resistance | 30 g, 11 ms in 6 spatial directions, 3 shocks 10 g, 16 ms in 6 spatial directions, 1000 shocks | |
| Vibration resistance | 0.35 mm / 5 g 5 ... 500 Hz | |
| Pollution degree | 3 | |
| Mechanical specifications | ||
| Degree of protection | IP67 / IP68 / IP69k | |
| Connection | IO-Link: M12 round plug connector in accordance with EN 61076-2-101, LM type (4-pin, connector contacts, screw-locking, A-coded) Female connector: LF type or similar IN: M8 round plug connector in accordance with EN 61076-2-104, LF type (4-pin, socket contacts, screw-locking, A-coded) Mating connector: LM type or similar |
|
| Material | ||
| Housing | PBT | |
| Mass | 110 g | |
| Tightening torque, cable gland | 0.4 Nm (M12 connector), 0.2 Nm (M8 connector) |
|
| Dimensions | ||
| Height | 29.35 mm | |
| Width | 30 mm | |
| Length | 143 mm | |
| Mounting | screw mounting | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27242604 |
| ECLASS 12.0 | 27242604 |
| ECLASS 11.0 | 27242604 |
| ECLASS 10.0.1 | 27242604 |
| ECLASS 9.0 | 27242604 |
| ECLASS 8.0 | 27242604 |
| ECLASS 5.1 | 27242604 |
| ETIM 9.0 | EC001597 |
| ETIM 8.0 | EC001597 |
| ETIM 7.0 | EC001597 |
| ETIM 6.0 | EC001597 |
| ETIM 5.0 | EC001597 |
| UNSPSC 12.1 | 32151705 |
Details: ICA-16DI-G16-IO
Function
The ICA-16DI-G16-IO is an IO-Link field module with 16 digital inputs.
The module and the inputs are supplied with power via IO-Link.
The inputs are connected via 4-pin M8 sockets. IO-Link is connected via a 4-pin M12 connector.
The current switching state or an overload of the inputs is indicated via LEDs.
Product Documentation: ICA-16DI-G16-IO
| Parameter Information | Język | Typ pliku | Rozmiar pliku |
|---|---|---|---|
| IO-Link Parameter Datasheet ICA-16DI-G16-IO | ENG | 338 KB |
Approvals: ICA-16DI-G16-IO
| Declaration of Conformity | Nr. certyfikatu | Język | Typ pliku | Rozmiar pliku |
|---|---|---|---|---|
| EU Declaration of Conformity (P+F) | TDOC-7805_POL | POL | 195 KB | |
| UK Declaration of Conformity (P+F) | TDOC-7806_ENG | ENG | 171 KB |
Software: ICA-16DI-G16-IO
| Device Description Files/Drivers | Informacja o wersji | Typ pliku | Rozmiar pliku |
|---|---|---|---|
| IODD for ICA-16DI-G16-IO / IODD für ICA-16DI-G16-IO | V1.00.000 / 2024-10-25 | ZIP | 215 KB |
| Software Tools | |||
| IO-Link Offline Parameterization Tool / IO-Link Offline-Parametriertool | V1.00.006 / 2022-07-10 | ZIP | 96138 KB |
W tym bezpłatnym opracowaniu w formacie PDF porównano różne protokoły komunikacyjne oparte na protokole TCP (AMQP, OPC UA, MQTT, REST API), które sprawdziły się w działaniu i uznawane są za podstawę rozwiązań IIoT oraz Przemysłu 4.0. Pobierz bezpłatny dokument już teraz!
Moduł KE5 do szaf sterowniczych AS-Interface — łatwa obsługa i zarządzanie
Unikalna konstrukcja obudowy nowych modułów do szaf sterowniczych KE5 zapewnia ich doskonałą widoczność oraz ułatwia montaż, podłączanie przewodów oraz wykonywanie zadań konserwacyjnych w szafach sterowniczych i skrzynkach połączeniowych.
Pepperl+Fuchs Sp. z o.o.
ul. Owsiana 12
03-825 Warszawa
Polska
NIP: 522-28-27-777
+48 22 256 9770
Pepperl+Fuchs jest czołową firmą konstruującą i produkującą czujniki elektroniczne oraz inne komponenty dla globalnego rynku automatyki. Innowacyjność, wysoka jakość oraz stały rozwój firmy powodują, iż z sukcesem jesteśmy obecni na rynku od ponad 70 lat. Pepperl+Fuchs zatrudnia ponad 6300 pracowników na całym świecie i ma swoje zakłady produkcyjne w Niemczech, USA, Singapurze, na Węgrzech, w Indonezji i Wietnamie. Większość z nich posiada certyfikat ISO 9001.