Fieldbus Barrier R4D0-FB-IA*
FieldConnex® Fieldbus
- 8 ... 12 outputs Ex ia IIC, FISCO and Entity
- Advanced fault isolation and diagnostics at the spur
- FieldBarrier in Zone 1/Div. 2
- Instruments in Zone 0...1/Div. 1
- For FOUNDATION Fieldbus H1 and PROFIBUS PA
- Supports plug-in surge protectors
- Very compact, small footprint
- Designed for high reliability
Please note: All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.
De complete datasheet als PDF downloaden:
Technische gegevens R4D0-FB-IA*
| Productbeschrijving |
|---|
| Fieldbus barrier, module for DIN rail mounting |
| General specifications | ||
|---|---|---|
| Design / Mounting | Cabinet installation | |
| Installation in hazardous area | Zone 1 / Div. 2 | |
| Fieldbus connection | ||
| Power dissipation | see table 1 | |
| Main cable (Trunk) | ||
| Rated voltage | 16 ... 32 V DC , min. 15 V in case of brown out |
|
| Rated current | trunk IN to trunk OUT max. 2 A see table 1 |
|
| Cable shield grounding option | Capacitive via 5.7 nF Direct |
|
| Voltage drop | trunk IN to trunk OUT 100 mV max. | |
| Number of couplers | max. 3 per segment | |
| Reverse polarity protection | Built-In | |
| Outputs | ||
| Number of outputs | 8, 10 or 12 | |
| Number of devices per output | 1 | |
| Cable length | 120 m | |
| Rated voltage | 10 ... 14 V | |
| Rated current | max. 43 mA at one spur , max. 320 mA total current at all spurs |
|
| Short-circuit current | 53 mA , 1 mA in fallback state | |
| Cable shield grounding option | Capacitive via 4.4 nF | |
| Surge protection | Trunk overvoltage protection if voltage exceeds typ. 39 V, max. 41 V | |
| Diagnostic and Protection Features | ||
| Fault Isolation | Short Circuit Current Limitation at spurs Bounce Protection at spurs Signal inhibit at spurs |
|
| Physical Layer Diagnostic | Signal level at spurs Signal jitter at spurs Noise level at spurs |
|
| Indicators/operating means | ||
| Switch | S1 ON: diagnostic alarms activated S2 ON: diagnostic warnings activated S3-S8: not used |
|
| LED PWR | green: Fieldbus voltage > 16 V | |
| LED COM/ERR | yellow flashing: fieldbus communication and physical layer status , red: Hardware error |
|
| LED SPURS | red: 2 Hz flashing in short-circuit condition | |
| Galvanic isolation | ||
| Main wire/outputs | isolation is not affected by interference according to EN 60079-11, voltage peak value 375 V | |
| Output/Output | No Isolation | |
| Directive conformity | ||
| Electromagnetic compatibility | ||
| Directive 2014/30/EU | EN 61326-1:2013 | |
| Standard conformity | ||
| Electromagnetic compatibility | NE 21:2011 | |
| Degree of protection | IEC/EN 60529 | |
| Fieldbus standard | IEC 61158-2 | |
| Climatic conditions | IEC 60721 | |
| Shock resistance | EN 60068-2-27 | |
| Vibration resistance | EN 60068-2-6 | |
| Ambient conditions | ||
| Ambient temperature | -40 ... 70 °C (-40 ... 158 °F) | |
| Storage temperature | -40 ... 85 °C (-40 ... 185 °F) | |
| Relative humidity | < 95 % non-condensing | |
| Shock resistance | 15 g 11 ms | |
| Vibration resistance | 1 g , 10 ... 150 Hz | |
| Corrosion resistance | acc. to ISA-S71.04-1985, severity level G3 | |
| Mechanical specifications | ||
| Connection type | screw terminal , pluggable or spring terminal , pluggable | |
| Core cross section | see table 2 | |
| Housing material | Polycarbonate | |
| Degree of protection | IP20 | |
| Mass | 2100 g | |
| Dimensions | see dimensions | |
| Mounting | DIN rail mounting | |
| Data for application in connection with hazardous areas | ||
| EU-type examination certificate | BVS 13 ATEX E 121 X | |
| Marking |  II 2(1)G Ex eb ib mb [ia Ga] IIC T4 Gb II (1)D [Ex ia Da] IIIC I (M1) [Ex ia Ma] I |
|
| Main cable (Trunk) | ||
| Maximum safe voltage | 253 V AC | |
| Outputs | in accordance to FISCO and Entity | |
| Power | 1.063 W | |
| Voltage | 17.1 V | |
| Current | 248.55 mA | |
| Inductance | gas group IIC 470 µH , gas group IIB 2 mH |
|
| Capacitance | gas group IIC 367 nF , gas group IIB 2.15 µF |
|
| Directive conformity | ||
| Directive 2014/34/EU | EN IEC 60079-0:2018+AC:2020 , EN 60079-7:2015+A1:2018 , EN 60079-11:2012 , EN 60079-18:2015 | |
| International approvals | ||
| CSA approval | CSA 14.70004139 | |
| Control drawing | 116-0400 | |
| Approved for | Class I, Division 2, Groups A, B, C, D T4 Class I, Zone 1, AEx/Ex e ib mb [ia Ga] IIC T4 Gb Class I, Zone 1, AEx/Ex e ib mb [ia IIC Da] IIC T4 Gb Associated equipment for Class I, Division 1 Groups A, B, C, D Associated equipment for Class II, Division 1 Groups E, F, G Associated equipment for Class III, Division 1 |
|
| IECEx approval | IECEx BVS 13.0119X | |
| Approved for | Ex eb ib mb [ia Ga] IIC T4 Gb [Ex ia Da] IIIC [Ex ia Ma] I |
|
| Certificates and approvals | ||
| FOUNDATION Fieldbus | FF-846 | |
| General information | ||
| Supplementary information | EC-Type Examination Certificate, Statement of Conformity, Declaration of Conformity, Attestation of Conformity and instructions have to be observed where applicable. For information see www.pepperl-fuchs.com. | |
Classifications
| System | Classcode |
|---|---|
| ECLASS 13.0 | 27242605 |
| ECLASS 12.0 | 27242605 |
| ECLASS 11.0 | 27242605 |
| ECLASS 10.0.1 | 27242605 |
| ECLASS 9.0 | 27242605 |
| ECLASS 8.0 | 27242605 |
| ECLASS 5.1 | 27242605 |
| ETIM 9.0 | EC001601 |
| ETIM 8.0 | EC001601 |
| ETIM 7.0 | EC001601 |
| ETIM 6.0 | EC001601 |
| ETIM 5.0 | EC001604 |
| UNSPSC 12.1 | 39121008 |
Details: R4D0-FB-IA*
Informative Literature: R4D0-FB-IA*
| Literature | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|
| Application Report - Controlling and Monitoring liquid Helium at the Deutsches Elektronen-Synchrotron | ENG | 361 KB | |
| Application Report - Digital Communication in Steel-Plate Manufacturing | ENG | 470 KB |
Product Documentation: R4D0-FB-IA*
| Safety and Security Documentation | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|
| Handleiding | HOL | 229 KB | |
| Manuals | |||
| Manual | ENG | 2866 KB | |
Design / Simulation: R4D0-FB-IA*
| CAD | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|
| CAD 2-D / CAD 2-D | ALL | ZIP | 1304 KB |
Approvals: R4D0-FB-IA*
| Certificates | Certificaatnummer | Taal | Bestandstype | Bestandsgrootte |
|---|---|---|---|---|
| BVS IECEx Certificate of Conformity | IECEx BVS 13.0119X | ALL | LINK | --- |
| Brasil TUV Rheinland Brazil | TÜV 14.1591 X | ALL | 1182 KB | |
| Canada, USA CSA Certificate of Compliance | CSA 14.70004139 | ALL | 323 KB | |
| China SITIIAS CCC Ex Certificate | 2020322316002483 (Singapore) | ALL | 1013 KB | |
| DNV Marine | TAA0000272 | ALL | 100 KB | |
| Europe BVS ATEX Category 2 (1) | BVS 13 ATEX E 121 X | ALL | 1469 KB | |
| United Kingdom CML UK-Type Examination Certificate UKEX Category (1) D UKEX Category (1) G UKEX Category (M1) | CML 23UKEX2145X | ALL | 181 KB | |
| Worldwide Fieldbus Foundation | DC090100 | ALL | 55 KB | |
| Control Drawings | ||||
| Control drawing CSA / Control drawing CSA | ALL | 343 KB | ||
| Declaration of Conformity | ||||
| EU Declaration of Conformity (P+F) | TDOC-0268EHOL | HOL | 1139 KB | |
Aanverwante producten: R4D0-FB-IA*
| Matching System Components | ||||||
|---|---|---|---|---|---|---|
|
||||||
|
||||||
| Accessories | ||||||
|
||||||
|
||||||
|
||||||
Producten
Pepperl+Fuchs N.V.
Metropoolstraat 11
2900 Schoten / Anvers
BELGIË
BTW BE 0436.097.152, RPR Antwerpen, afd. Antw.
sales@be.pepperl-fuchs.com
+32 3 644 25 00
© 2024 Alle rechten voorbehouden.
Pepperl+Fuchs is een toonaangevend ontwikkelaar en producent van elektronische sensoren en componenten voor de wereldwijde automatiseringsmarkt. Continue innovatie, hoge kwaliteit en gestage groei zijn de basis van ons succes, al meer dan 70 jaar. Pepperl+Fuchs heeft wereldwijd 6300 medewerkers en productiefaciliteiten in Duitsland, de Verenigde Staten, Singapore, Hongarije, Indonesië en Vietnam, waarvan het merendeel ISO 9001 gecertificeerd.